Globally, most bridges fail due to hydrological causes such as scouring or flooding. Therefore, using a hydrological approach, this study proposes a methodology that contributes to prioritizing the intervention of bridges to prevent their collapse. Through an exhaustive literature review, an evaluation matrix subdivided into four dimensions was developed and a total of 18 evaluation parameters were considered, distributed as follows: four environmental, six technical, four social, and four economic. This matrix was applied to eight bridges with a history of hydrological problems in the same river and validated through semi-structured interviews with specialists. Data were collected through field visits, journalistic information, a review of the gauged basin’s historical hydrological flow rates, and consultations with the population. Modeling was then conducted, which considered the influence of gullies that discharge additional flow using HEC-HMS and HEC-RAS, before being calibrated. The application of the matrix, which is an optimal tool for prioritizing bridge interventions, revealed that five bridges have a high vulnerability with scores between 3 and 3.56, and three bridges have a medium vulnerability with scores between 2.75 and 2.94. The hydrological multidimensional approach, which can be adapted for similar studies, contributes to a better decision-making process for important infrastructure interventions such as riverine bridges.
Non-Newtonian debris flows represent a critical challenge for hydraulic infrastructure in mountainous regions, often causing significant damage and service disruption. However, current models typically simplify these flows as Newtonian, leading to inaccurate design assumptions. This study addresses this gap by comparing the hydraulic behavior of Newtonian and non-Newtonian flows in an alluvial fan, using the Amoray Gully in Apurímac, Peru, as a case study. This gully intersects the Interoceánica Sur national highway via a low-water crossing (baden), making it a relevant site for evaluating debris flow impacts on critical road infrastructure. The methodology integrates hydrological analysis, rheological characterization, and hydraulic modeling. QGIS 3.16 was used for watershed delineation and extraction of physiographic parameters, while a high-resolution topographic survey was conducted using an RTK drone. Rainfall-runoff modeling was performed in HEC-HMS 4.7 using 25 years of precipitation data, and hydraulic simulations were executed in HEC-RAS 6.6, incorporating rheological parameters and calibrated with the footprint of a historical event (5-year return period). Results show that traditional Newtonian models underestimate flow depth by 17% and overestimate velocity by 54%, primarily due to unaccounted particle-collision effects. Based on these findings, a multi-barrel circular culvert was designed to improve debris flow management. This study provides a replicable modeling framework for debris-prone watersheds and contributes to improving design standards in complex terrain. The proposed methodology and findings offer practical guidance for hydraulic design in mountainous terrain affected by debris flows, especially where infrastructure intersects active alluvial fans.
Riverine bridges are critical infrastructure that are increasingly exposed to severe hydrological hazards. This study proposes and validates a synergistic methodology for the assessment of riverine bridge resilience, integrating the conceptual 4R framework (robustness, rapidity, resourcefulness, and redundancy) with field inspections, hydrological and hydraulic modeling, including scour evaluation, within a multicriteria analysis scheme. The methodology comprises: (i) a systematic review of literature and regulations to construct a 30-parameter matrix across five dimensions (technical, economic, social, organizational, and environmental); (ii) data acquisition through field inspections, detailed topography, and technical studies; and (iii) one-dimensional hydraulic modeling in HEC-RAS under extreme scenarios (return periods of 100 to 750 years and a critical 500 m3/s scenario representing a potential overflow of the Aguada Blanca reservoir). The Bridge Resilience Index (BRI) is computed through a weighted additive model and a sensitivity analysis. Application to the San Martín Bridge (Arequipa, Peru), a structure with more than 60 years of service and recurrent preventive closures during flood events, revealed critical conditions: minimum freeboard of 0.26 m, absence of hydraulic protections, and limited institutional capacity. The resulting BRI value (1.898) indicates a low resilience level. The proposed framework provides a useful tool for risk-informed decision-making, the prioritization of interventions, and the strengthening of resilience in critical infrastructure.
This paper presents an experimental campaign conducted next to the Condoroma dam, in Perú, at 4075 m a.s.l. The tests carried out in this paper were conducted in a 21 m long channel located at the toe of Condoroma dam. The setup consisted of a series of standard profile spillways with a vertical upstream face of up to five different dimensionless heights (P/Hd) ranging from 0.5 to 2. The experimental results indicated that, the P/Hd ratio influences the discharge coefficients in Condoroma, and P/Hd ≥ 1 values are recommended for the design of the spillway profile. In addition, for all the P/Hd ratios studied, the discharge coefficients adjusted to the Condoroma altitude were lower than those reported by classical formulations used in conventional spillway designs. Finally, a generalized equation is proposed to estimate the discharge coefficient for standard spillways located in dams at similar elevations above sea level.
18 August 2026 in Flow Measurement and Instrumentation
This paper presents the experimental campaign conducted near the Condoroma dam at 4075 m a.s.l. in an experimental setup consisting of a series of standard profile spillways with a vertical upstream face of up to five different dimensionless heights (P/Hd). The experimental results indicate that for all P/Hd ratios studied, the discharge coefficients adjusted to the Condoroma altitude are lower than those reported by classical formulations used in conventional spillway design. As a result, a generalized equation is proposed to estimate the discharge coefficient for standard spillways located in dams at similar elevations above sea level.