With the aim of promoting the qualities for total hip joint replacement, the wettability and tribological behaviors of PEEK composites pins with two sets of different fillers (PEEK/CF or PEEK/CF/PTFE/graphite) against Co-Cr alloy discs with five categories of surface textures (polished, orthogonal, spiral, r-θ, and orthogonal combined with spiral) were explored. It is revealed that the existence of CF in PEEK matrix increases the hydrophilicity in addition to the strength of PEEK, while the addition of PTFE increases the hydrophobicity of PEEK. The Co-Cr alloy discs with hydrophilic properties can be adjusted as hydrophobic, with the depth of textured grooves exceeding the critical sag height determined by the contact angle and the groove width. It can be concluded that PEEK/CF/PTFE/graphite composite has a lower wear rate than PEEK only reinforced with CF against Co-Cr alloy, both without surface texture and with shallow or deep grooves. The existence of shallow grooves on the disc surface could help the PEEK blends to achieve a steady friction against Co-Cr alloy in addition to collecting the worn debris. PEEK blend pins with 10 vol% CF, 10 vol% PTFE and 10 vol% graphite can achieve a lower friction coefficient of no more than 0.2 against Co-Cr alloy discs with shallow grooves around 3.5 μm in orthogonal or spiral textures.
With excellent creep resistance, high-temperature thermal strength and high-temperature fatigue strength, Inconel 625 is widely applied to fabricate structural components in the aerospace field, where fatigue life is a key point. Laser shock peening (LSP) is considered to improve the fatigue strength and fatigue crack growth resistance of metal materials. The present work was conducted to investigate the influence of LSP on strain-controlled fatigue behavior of Inconel 625. The surface microstructures of specimens before and after LSP were observed by transmission electron microscope (TEM). The strain-controlled fatigue loading tests with different strain amplitudes ranging from 0.4% to 1.2% were carried out on the specimens, and the topography of fracture appearance was examined by scanning electron microscope (SEM). The investigations showed that the specimens with LSP presented fewer crack initiations, shorter fatigue striations space and smaller dimples or micropores, which account for the enhancement of the fatigue life for the LSP specimens. Furthermore, the plastic deformation, ultra-fine grains, twins and dislocations caused by LSP could prevent crack initiation, crack propagation and ultimate fracture, hence prolonging the fatigue life of the Inconel 625. In addition, it was revealed that the cyclic strain hardening as well as cyclic strain softening remains almost the same to Inconel 625 with or without LSP.