Background: A major inhibitor in the development and certification of non-destructive test equipment is the lack of access to statistically appropriate numbers of test pieces which contain relevant flaws. Methods of introducing these flaws in a controllable and repeatable manner are always in demand. Methods: This paper discusses the development and evaluation of a method for seeding contact cracks in ASTM F519-18 Type 1a.1 notched tensile coupons. Contact cracks of controlled dimensions are successfully introduced into a set of these specimens by closely monitoring the resonance frequency and peak splitting due to anisotropy. Results: Results are confirmed using Scanning Electron Microscopy, carried out on a selection of the coupons. The least exposed coupon was shown to have a crack propagating inwards from the notch with a length of approximately 50 microns. More heavily exposed samples had longer cracks spanning nearly the entire notch with a crack width of 1.3 microns. Conclusions: The correlation between crack growth and the frequency monitoring proves that this technique could be further developed for the controlled creation of contact cracks for NDT validation or other applications.
Techniques for the controlled seeding and growth of cracks are urgently required for non-destructive testing technique evaluation, particularly for additive manufactured (AM) samples. This paper describes a method that uses a combination of the tensile load and the resonance excitation of notched AM samples, with in situ monitoring of the resonance frequency serving to track the crack dimensions. Mechanical low-cycle fatigue cracks, ranging in length from ~0.3 mm to ~5 mm, were successfully created in five AM samples using this technique. The samples were non-destructively characterized using optical microscopy and Nonlinear Resonance (NLR) testing. The exploitation of resonance enabled the concentration of a significant number of stress cycles on the samples in much shorter timespans than conventional fatigue testing, enabling a high throughput while utilizing compact components. Furthermore, the tracking of the resonance frequency shift throughout the process enabled non-invasive and no-contact real-time condition monitoring.
Techniques for the controlled seeding and growth of cracks are urgently required for non-destructive testing technique evaluation, particularly for additive manufactured (AM) samples. This paper describes a method which uses a combination of tensile load and resonance excitation of notched AM samples, with in-situ monitoring of the resonance frequency serving to track crack dimensions. Mechanical low-cycle fatigue cracks, ranging in length from ~0.3 mm to ~5 mm, are successfully created in five AM samples using this technique. The samples are non-destructively characterized using optical microscopy and Nonlinear Resonance (NLR) testing. The exploitation of resonance enables the concentration of a significant number of stress cycles on the samples in much shorter timespans than conventional fatigue testing, enabling high throughput, while utilising compact components. Furthermore, the tracking of resonance frequency shift throughout the process enables non-invasive and non-contact real-time condition monitoring.