Quanbin REN

Quanbin REN


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 September 2023 in Aerospace
Verified
Journal Article
Open access
PDF file
SSShixiong Song
Shixiong Song
QRQuanbin REN
Quanbin REN
MTMin Tang
Min Tang
JSJiawei Shi
Jiawei Shi
JWJiawei Wang
Jiawei Wang
Fused deposition technology (FDM), as an additive manufacturing (AM) technology, holds immense potential in the field of solid grain manufacturing. It can accomplish complex grain shaping with ultra-low-pressure ratios, which are challenging to achieve using conventional grain manufacturing processes. In this work, solid propellants with complex structures were made by using 3D printing. The obtained sample grains of the solid propellants had a complete structure, which conformed to the design model and had no obvious defects. Then, the combustion and mechanical properties of the printed solid propellant were obtained and analyzed. The results show that the composition of the printed solid propellant is more uniform and the performance is better than that of the conventional solid propellant. In addition, by conducting a motor experiment, it was verified that the 3D-printed grains with complex structures have the characteristic of an “ultra-low pressure ratio”. The comparative analysis revealed that the maximum working pressure was reduced by about 19.5%, the bearing load of the shell was reduced, and the mass of the shell and other bearing parts was reduced by 11.5%. The research in this paper shows that 3D-printed solid propellant technology can realize the formation of grains with complex structure, which can directly promote the solid rocket motor to obtain the “ultra-low pressure ratio” characteristic, and greatly improve the performance of solid rocket motors.

10 February 2025 in Materials
Verified
Journal Article
Open access
PDF file
SSShixiong Song
Shixiong Song
JSJiawei Shi
Jiawei Shi
QRQuanbin REN
Quanbin REN
KMKai Miao
Kai Miao
MTMin Tang
Min Tang
HSHongbin Shi
Hongbin Shi
Extrusion-based 3D printing holds great potential for manufacturing solid propellants. Among the various methods, screw- and plunger-based extrusion are the most frequently reported techniques for propellant 3D printing, each employing different extrusion mechanisms. This paper compares the flow characteristics of these two methods through a combination of simulations and experiments. Simulation results reveal that propellant slurry in a plunger extrusion device exhibits relatively stable flow characteristics, especially near the nozzle outlet, with high flow velocity, high shear rate, and low-pressure distribution. Compared to the screw-based device, the plunger extrusion achieves a more uniform outlet velocity. In contrast, the screw extrusion device produces more complex rheological behavior, with backflow observed in the gap between the screw and the extrusion channel wall. However, the average pressure in the flow channel for screw extrusion (3885.11 Pa) is notably lower than that of plunger extrusion (7292.92 Pa). Experimental results indicate that the printing quality of plunger extrusion is comparable to that of screw extrusion. These findings provide valuable insights into advancing extrusion-based 3D-printing processes for solid propellants.