It is well established that the microstructure has significant effects on the properties of axial braided C/C composites. In this study, a method coupling the homogenization method and finite element method (FEM) was proposed to predict the relationship between the microstructure characteristics and macroscopic properties. Based on the representative volume element (RVE) model, the periodic displacement boundary condition was introduced to predict the equivalent elastic properties of the RVE and component of C/C composite material, and the coefficient of thermal expansion (CTE) of the material was predicted by the energy prediction method. The predicted results were in good agreement with experimental results. By predicting the thermal and mechanical properties of the materials with different braiding spacing and fiber rod diameter, the variation of the properties with braiding spacing and fiber rod diameter was obtained. The research methods and results in this paper could provide important references for the optimization and rational application of composite materials.
Extrusion-based 3D printing holds great potential for manufacturing solid propellants. Among the various methods, screw- and plunger-based extrusion are the most frequently reported techniques for propellant 3D printing, each employing different extrusion mechanisms. This paper compares the flow characteristics of these two methods through a combination of simulations and experiments. Simulation results reveal that propellant slurry in a plunger extrusion device exhibits relatively stable flow characteristics, especially near the nozzle outlet, with high flow velocity, high shear rate, and low-pressure distribution. Compared to the screw-based device, the plunger extrusion achieves a more uniform outlet velocity. In contrast, the screw extrusion device produces more complex rheological behavior, with backflow observed in the gap between the screw and the extrusion channel wall. However, the average pressure in the flow channel for screw extrusion (3885.11 Pa) is notably lower than that of plunger extrusion (7292.92 Pa). Experimental results indicate that the printing quality of plunger extrusion is comparable to that of screw extrusion. These findings provide valuable insights into advancing extrusion-based 3D-printing processes for solid propellants.
In order to study the microstructure characteristics of an axially braided Carbon/Carbon (C/C) composite, a comprehensive observation and study of the mesoscopic and microstructure characteristics of an axially braided C/C composite is conducted. Scanning electron microscopy and Micro-CT were used to obtain the microstructure characteristics and distribution rules of the axially braided C/C composite material. The physical model of the material and the geometric model of the representative unit were established. At the same time, the characteristics of this kind of material are also obtained. The microstructure characteristics show that the axially braided C/C composite is a polymer with cracks and pores of different sizes, which is a three-dimensional and four-directions carbon fiber braided body as the reinforcing phase and pitch carbon as the reinforcing matrix. The microcosmic data obtained in this chapter is the basis for carrying out material property prediction and qualitative comparison of macro performance.
Fused deposition technology (FDM), as an additive manufacturing (AM) technology, holds immense potential in the field of solid grain manufacturing. It can accomplish complex grain shaping with ultra-low-pressure ratios, which are challenging to achieve using conventional grain manufacturing processes. In this work, solid propellants with complex structures were made by using 3D printing. The obtained sample grains of the solid propellants had a complete structure, which conformed to the design model and had no obvious defects. Then, the combustion and mechanical properties of the printed solid propellant were obtained and analyzed. The results show that the composition of the printed solid propellant is more uniform and the performance is better than that of the conventional solid propellant. In addition, by conducting a motor experiment, it was verified that the 3D-printed grains with complex structures have the characteristic of an “ultra-low pressure ratio”. The comparative analysis revealed that the maximum working pressure was reduced by about 19.5%, the bearing load of the shell was reduced, and the mass of the shell and other bearing parts was reduced by 11.5%. The research in this paper shows that 3D-printed solid propellant technology can realize the formation of grains with complex structure, which can directly promote the solid rocket motor to obtain the “ultra-low pressure ratio” characteristic, and greatly improve the performance of solid rocket motors.