The AASHTO:TP-79 (2010), Standard method of test for determining the dynamic modulus and flow number for hot mix asphalt using the asphalt mixture performance tester (AMPT) stipulates the test procedure for the measurement of dynamic modulus of bituminous mixtures. In this test, the stress–strain–time data for different frequencies (from 25 to 0.01 Hz) are generated and used in the calculation of dynamic modulus. In this investigation, dynamic modulus data of four types of bituminous concrete mixtures (an unmodified binder and three modified binders) are studied using this protocol. The experiments showed that the total strain decreased with time at higher temperatures and at lower frequencies while at lower temperatures and higher frequencies, the total strain was seen increasing. It was also observed that at higher temperatures and low frequencies, the phase lag decreased with a decrease in frequency. While many studies have reported such results, these are normally called as ‘anomalous’ and ascribed to the errors in measurement mechanisms. These observations seem to have not been investigated within the context of the viscoelastic behaviour of the material. This study shows that the so called ‘anomaly’ is a response shown by a viscoelastic material. In the current study, the analysis of the data showed that the increasing and decreasing trend in strain can be attributed to two phenomena: the creep due to successive loading and the recovery of the residual deformation in the material due to a reduction in load level. It is demonstrated that the observed material response for the test conducted as per this test procedure can be qualitatively predicted using many viscoelastic models, however, one has to take into account the entire load history.
The use of recycled asphalt pavements (RAPs) has been a common practice in recent times owing to the sustainability aspect as well as the cost savings. Characterization of RAP is a challenging task because of the high variability in RAP, which can be associated with several factors such as the source, milling method, and processing techniques. RAP material characterization requires a sophisticated material testing facility and is time-intensive. A round-robin test organized by the International Union of Laboratories and Experts in Construction Materials, Systems, and Structures (RILEM) Technical Committee 237-SIB has resulted in a new characterization protocol that is primarily intended for new construction, rehabilitation, and maintenance requirements of pavements utilizing RAP. The current study has adopted the RILEM recommendations to categorize RAP from various sources using basic tests: gradation and cohesion. RAPs obtained from seven sources, including artificially aged RAP, were investigated in the current study, and the tests were carried out on 100 % RAP. The allowable proportion of RAP that could be used for the hot-mix asphalt mix design was computed for all seven RAP sources using the blending charts. Furthermore, significant correlations were obtained between the allowable RAP content and the cohesion indices. The observations from this study suggest that basic tests, such as cohesion tests, can reduce the need for complicated test procedures to some extent and can be very advantageous for extensive field projects using RAP.