A modular, multi-purpose, and cost-effective electrochemical biosensor based on a five-stranded four-way junction (5S-4WJ) system was developed for SARS-CoV-2 (genes S and N) and Influenza A virus (gene M) detection. The 5S-4WJ structure consists of an electrode-immobilized universal stem-loop (USL) strand, two auxiliary DNA strands, and a universal methylene blue redox strand (UMeB). This design allows for the detection of specific nucleic acid sequences using square wave voltammetry (SWV). The sequence-specific auxiliary DNA strands (m and f) ensure selectivity of the biosensor for target recognition utilizing the same USL and UMeB components. An important feature of this biosensor is the ability to reuse the USL-modified electrodes to detect the same or alternative targets in new samples. This is accomplished by a simple procedure involving rinsing the electrodes with water to disrupt the 5S-4WJ structure and subsequent re-hybridization of the USL strand with the appropriate set of strands for a new analysis. The biosensor exhibited minimal loss in signal after rehybridization, demonstrating its potential as a viable multiplex assay for both current and future pathogens, with a low limit of quantification (LOQ) of as low as 17 pM.
Template removal represents a critical yet often underexplored step in the fabrication of electropolymerized molecularly imprinted polymers (e-MIPs), directly influencing cavity integrity, selectivity, and sensor performance. In this review, we provide a comprehensive analysis of the most commonly employed template removal strategies, including immersion-based methods and electrochemical cleaning, with a particular focus on systems based on polypyrrole (PPy) and poly(o-phenylenediamine) (PoPD). We examine how template removal conditions, such as solvent composition, pH, and applied potential, affect polymer structure, doping state, swelling behavior, and electrochemical properties. Special attention is given to mechanistic aspects such as protonation/deprotonation, overoxidation, and polymer–template interactions, which govern both remotion efficiency and potential degradation pathways. By comparing PPy and PoPD systems, we highlight how intrinsic polymer properties dictate the suitability of specific removal strategies. Additionally, we discuss emerging approaches, including multi-step template removal protocols and the incorporation of conductive nanomaterials to mitigate performance loss. This work aims to provide a mechanistic perspective on how template removal conditions affect polymer structure, electrochemical properties, and the overall performance of e-MIP-based sensors.
Discriminating single-nucleotide variations at the terminal regions of short nucleic acids remains a major challenge for hybridization-based electrochemical biosensors, as terminal mismatches often produce insufficient destabilization for selective recognition. This limitation is particularly relevant for microRNAs and isomiRNAs, which frequently differ by only one or a few nucleotides at the 3′-or 5′-termini. Here, we report the first electrochemical adaptation of the OWL DNA architecture as a rigid multistrand platform for sequence-selective nucleic acid detection. The system employs a thiolated methylene blue-labeled stem–loop probe that assembles on the electrode surface only in the presence of the correct target sequence through cooperation with two auxiliary strands. Electrochemical characterization revealed a signaling regime distinct from conventional duplex sensors: whereas duplex controls displayed frequency-dependent switching behavior, the OWL architecture produced consistent signal suppression without signal inversion. The critical frequency of the assembled OWL structure remained comparable to that of the unhybridized probe, suggesting that incomplete surface assembly contributes to the observed response. The sensor exhibited a limit of detection and limit of quantification of 4 and 12 nM, respectively. Importantly, targets containing single mismatches at either the 3′ or 5′ termini produced significantly lower responses, demonstrating effective terminal single nucleotide polymorphism (SNP) discrimination. Preliminary matrix studies showed preserved functionality in diluted artificial urine and artificial saliva, whereas serum introduced significant signal variations. These findings establish OWL-based E-biosensors as promising recognition elements for electrochemical nucleic acid sensing with Single Nucleotide Polymorphism discrimination and provide insight into electron transfer within multistrand DNA assemblies at electrode interfaces
Discriminating single-nucleotide variations at the terminal regions of short nucleic acids remains a major challenge for hybridization-based electrochemical biosensors (E-biosensors), as terminal mismatches often produce insufficient destabilization for selective recognition. This limitation is particularly relevant for microRNAs and isomiRNAs, which frequently differ by only one or a few nucleotides at the 3′ or 5′ termini. Here, we investigate the electrochemical behavior of the OWL DNA architecture following its integration into a surface-confined sensing platform. Beyond demonstrating electrochemical target recognition, we examine how structural rigidity influences electron-transfer dynamics, signal generation, and terminal single-nucleotide polymorphism (SNP) discrimination relative to conventional duplex probes. Electrochemical characterization revealed a signaling mechanism distinct from duplex sensors: whereas duplex controls displayed frequency-dependent signal inversion, the OWL architecture produced consistent signal suppression over the explored frequency range. Additionally, targets containing single mismatches at either the 3′ or 5′ termini produced significantly lower responses, demonstrating effective terminal SNP discrimination. Preliminary matrix studies showed preserved functionality in diluted artificial urine and artificial saliva, whereas serum introduced significant signal variations. These findings establish rigid multistrand DNA architectures as promising recognition elements for electrochemical nucleic acid sensing and provide mechanistic insight into electron transfer within surface-confined DNA assemblies.