Copper Zinc Tin Sulphide (CZTS) is a propitious semiconductor for active absorber material in thin-film solar cells (SCs). Here, SC architecture comprising FTO/ZnS/CZTS/variable HTLs/Au is discussed. Fluorine-doped tin oxide (FTO) and gold (Au) are used as front and back contacts, respectively. Zinc sulphide (ZnS) is used as an active electron transport layer (ETL), while different Cu-based materials (Cu2O, CuO, CuI, and CuSCN) are used as hole transport layers (HTL). A one-dimensional solar cell capacitance simulator (SCAPS-1D) is utilized to simulate the SC structure. Among different Cu-based HTLs, Cu2O is preferred as a potential candidate for high cell performance of CZTS-based SC. The effects of various layer parameters such as thickness, doping density, and carrier concentrations, electron affinity of HTL and absorber, respectively, are also discussed. After optimization of the device, variation of operating temperature and the effect of series and shunt resistance are also taken into consideration. The optimized results of thickness and acceptor concentration (NA) of absorber material are 1.5 µm and approx. 1.0 × 1019 cm−3, respectively. In addition, the function of HTL (with and without) in the designed SC structure is also studied. Capacitance–voltage (C–V) characteristics are also discussed to get an insight of built-in potential. We have achieved cell performances viz. efficiency = 31.86%, short circuit current density = 32.05 mA/cm2, open circuit voltage = 1.19 V, and fill factor = 83.37%.
13 March 2023 in Journal of Materials Science: Materials in Electronics
Here we demonstrate a facile approach to grow uniform and large area single layer graphene directly over polycrystalline metal foil from fullerene, where fullerene molecules formed rod-like polycrystals in the toluene solvent. The generated pressure on sandwich structures has enhanced the density (scalable) as well as quality of graphene at partially low temperatures.
We established a cost-effective, scalable, and sustainable process to form single layer graphene from an inexpensive and common polymer at partially low temperature. The generated pressure and the metal capping layer on the polymer may control the evaporation rate and assist the transformation into graphene. This approach will have great advantages because of its simple, inexpensive, and nontoxic process.