Natural gas hydrates (NGHs) in the Shenhu area of the South China Sea are deposited in low-permeability clayey silt sediments. As a renewable energy source with such a low carbon emission, the exploitation and recovery rate of NGH make it difficult to meet industrial requirements using existing development strategies. Research into an economically rewarding method of gas hydrate development is important for sustainable energy development. Hydraulic fracturing is an effective stimulation technique to improve the fluid conductivity. In this paper, an efficient three-dimensional embedded discrete fracture model is developed to investigate the production simulation of hydraulically fractured gas hydrate reservoirs considering the stimulated reservoir volume (SRV). The proposed model is applied to a hydraulically fractured production evaluation of vertical wells, horizontal wells, and complex structural wells. To verify the feasibility of the method, three test cases are established for different well types as well as different fractures. The effects of fracture position, fracture conductivity, fracture half-length, and stimulated reservoir volume size on gas production are presented. The results show that the production enhancement in multi-stage fractured horizontal wells is obvious compared to that of vertical wells, while spiral multilateral wells are less sensitive to fractures due to the distribution of wellbore branches and perforation points. Appropriate stimulated reservoir volume size can obtain high gas production and production efficiency.
The technique of refracturing is an effective method to solve the rapid decline in oil well production caused by factors such as severe reservoir energy loss and fracture failure after the initial hydraulic fracturing of low-permeability reservoirs. The key to designing refracturing lies in establishing a model for evaluating the potential fracturing layers. Based on the geological characteristics of the low-permeability conglomerate reservoir in the Lower Wuerhe area of the Eig District of the Xinjiang Oilfield, this paper studies the influence of different development approaches on the distribution pattern of remaining oil in the reservoir. A coupled model of remaining oil distribution and the in situ stress field is established and discusses the characteristics of the four-dimensional in situ stress field under different development modes. This paper analyzes the influence of geological factors and well network factors on the distribution of residual oil, and analyzes the influence of various factors, such as reservoir properties and injection and extraction parameters, on ground stress. Based on the residual oil distribution and ground stress changes, an evaluation method for screening potential fractured layers in reservoirs with different development modes (water injection development and depletion development) is developed.