The technique of refracturing is an effective method to solve the rapid decline in oil well production caused by factors such as severe reservoir energy loss and fracture failure after the initial hydraulic fracturing of low-permeability reservoirs. The key to designing refracturing lies in establishing a model for evaluating the potential fracturing layers. Based on the geological characteristics of the low-permeability conglomerate reservoir in the Lower Wuerhe area of the Eig District of the Xinjiang Oilfield, this paper studies the influence of different development approaches on the distribution pattern of remaining oil in the reservoir. A coupled model of remaining oil distribution and the in situ stress field is established and discusses the characteristics of the four-dimensional in situ stress field under different development modes. This paper analyzes the influence of geological factors and well network factors on the distribution of residual oil, and analyzes the influence of various factors, such as reservoir properties and injection and extraction parameters, on ground stress. Based on the residual oil distribution and ground stress changes, an evaluation method for screening potential fractured layers in reservoirs with different development modes (water injection development and depletion development) is developed.
A tight conglomerate is mechanically heterogeneous because gravel particles, the matrix, and their contacts can perturb hydraulic-fracture paths. This study presents an exploratory comparison of three 2.0 m × 2.0 m × 1.0 m reconstituted conglomerate specimens, identified as specimen 97 (Condition A), specimen 98 (Condition B), and specimen 99 (Condition C). One meter-scale specimen was tested under each formulation condition using the same applied boundary stresses, nominal pumping rate, and fluid viscosity. Post-fracturing surface observations, inlet-pressure histories, and laboratory acoustic-emission (AE) event locations were examined. After event-quality control, DBSCAN-based spatial filtering was performed in Z-score-standardized coordinates, and three-dimensional alpha shapes were constructed from the retained event coordinates in meters to calculate geometric AE-event-envelope volumes. The external surface-fracture traces were more spatially distributed in specimen 97 and more localized in specimen 99. The available DBSCAN–alpha-shape calculation outputs yielded geometric AE-event-envelope volumes of 0.2832, 0.2460, and 0.0937 m3 for specimens 97, 98, and 99, respectively. Because only one specimen was tested under each condition, the specimen formulations and gravel characteristics were not identical, the gravel–matrix interfacial properties were not measured directly, and the pumping histories differed, the observations were interpreted as descriptive case differences rather than as a statistically validated single-factor relationship.
This study investigates the effects of CO2–water–rock interactions on shale oil reservoirs, specifically focusing on the mineral dissolution and pore structure alterations in shale samples from the second section of the Permian Fengcheng Formation in the Mahu Depression, Junggar Basin. Core soaking experiments were conducted under high-temperature and high-pressure conditions to simulate reservoir environments. Mineral evolution, ion migration, and microstructural changes were qualitatively and quantitatively analyzed using X-ray Diffraction (XRD), Inductively Coupled Plasma (ICP) spectroscopy, and Scanning Electron Microscopy (SEM). The findings indicate that CO2-induced mineral dissolution follows a distinct sequence: calcite > dolomite > potassium feldspar > sodium feldspar, which is directly reflected in the concentration of ions (Ca2+ > Mg2+ > K+ > Na+) in the solution. The dissolution rate and pore structure enhancement are significantly influenced by lamina density, with dolomitic rocks with high lamina density showing greater dissolution and porosity increase, and the lamina area greater than the matrix area. This study demonstrates that the dynamic changes of rock minerals are the core mechanism for controlling the pore structure of reservoirs, showing how CO2–water–rock reaction enhances the porosity and connectivity of shale reservoirs, thereby improving oil recovery potential.
Supercritical CO2 injection can mitigate depletion-induced deterioration of shale oil, but the relationship between laboratory-scale fluid-property changes and field-scale recovery remains insufficiently understood. This study integrates time-lapse produced-oil characterization, high-pressure PVT experiments, whole-hydrocarbon gas chromatography, and compositional reservoir simulation for the Mabei shale oil reservoir. From October 2023 to October 2025, the viscosity of dehydrated and degassed produced oil at 80 °C increased from 20.93 to 56.8 mPa·s, accompanied by depletion of light hydrocarbons and enrichment of heavy components, indicating progressive compositional deterioration during depletion. At 106.75 °C and 65.07 MPa, increasing the added CO2/oil molar ratio from 0 to 80% reduced live-oil viscosity from 9.7841 to 3.8470 mPa·s and density from 0.8326 to 0.7897 g/cm3. Most viscosity, density, and oil-phase compositional changes occurred within the first 6 h in the closed, continuously stirred PVT cell. CO2 contact preferentially transferred C3–C7 hydrocarbons out of the analyzed oil-rich phase, resulting in relative enrichment of C15–C37 components in the residual oil. The history-matched compositional model showed that CO2 improved reservoir pressure maintenance and expanded low-viscosity regions primarily along fracture-connected flow paths, although the incremental response became limited between the 20 and 25% cases. Regional compositional analysis further demonstrated that strongly CO2-contacted residual oil became heavier, whereas the produced oil was enriched in mobilized light and intermediate hydrocarbons. These results establish a consistent laboratory-to-field interpretation of CO2-induced compositional redistribution and provide a basis for optimizing CO2-assisted development in deeply buried shale oil reservoirs. CO2-induced asphaltene precipitation/deposition and the associated permeability impairment were not measured or represented in the numerical model. Therefore, the reported recovery response reflects CO2–oil property and transport effects in the absence of solid-phase formation damage.