Shaopeng Wu

Prof. Shaopeng Wu

State Key Laboratory of Silicate Materials for Architectures, Wuhan University of Technology, Wuhan 430070, China

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2021 in Journal of Hazardous Materials
Verified
Journal Article
Closed access
PCPeide Cui
Peide Cui
Shaopeng WuShaopeng Wu
Shaopeng Wu
Yue XiaoYue Xiao
Yue Xiao
RHRui Hu
Rui Hu
TYTianyuan Yang
Tianyuan Yang


1 August 2010 in Journal of Materials in Civil Engineering
Verified
Journal Article
Closed access
Shaopeng WuShaopeng Wu
Shaopeng Wu
LPLing Pang
Ling Pang
Gang LiuGang Liu
Gang Liu
JZJiqing Zhu
Jiqing Zhu
The effects of ultraviolet (UV) radiation on degradation of bitumen have received much attention from both academic and industrial points of view. However, quantitative evaluations of bitumen photo-oxidation in pavements have apparently not been determined. In this study, the effects of photo-oxidation of bitumen were investigated by exposing pressed thin films of bitumen. The data for thermal aging only were compared with corresponding data for photo-oxidation from exposure to UV radiation. The levels of aging were evaluated by following increases in the carbonyl functional group, and increases in viscosity. The results indicated that both thermal and UV aging occurred during exposure in the UV radiation oven test for thin bitumen films of both unmodified and SBS-modified bitumen. UV aging had a significant effect on bitumen properties, particularly when the bitumen film thickness was less than 150 μm . Results also showed that the level of UV irradiation intensity had a significant influence on the leve...

1 March 2022 in Journal of Hazardous Materials
Verified
Journal Article
Closed access
Xinxing ZhouXinxing Zhou
Xinxing Zhou
Liang ShiLiang Shi
Liang Shi
TMTaher Baghaee Moghaddam
Taher Baghaee Moghaddam
MCMeizhu Chen
Meizhu Chen
Shaopeng WuShaopeng Wu
Shaopeng Wu
XYXiangzhou Yuan
Xiangzhou Yuan

6 May 2017 in Materials
Verified
Journal Article
Open access
PDF file
DZDong Zhang
Dong Zhang
MCMeizhu Chen
Meizhu Chen
Shaopeng WuShaopeng Wu
Shaopeng Wu
JLJingxiang Liu
Jingxiang Liu
Serji AmirkhanianSerji Amirkhanian
Serji Amirkhanian
Waste cooking oil (WCO), in many cases, can rejuvenate aged asphalt and restore its properties. However, the influence of WCO qualities on rejuvenation behaviors of aged asphalt has not been investigated in detail. The objective of this paper was to evaluate the effects of WCO viscosity and acid value on the basic, rheological, and chemical properties of a typical rejuvenated asphalt. Penetration, ring and ball (R and B) softening point, and ductility were tested to evaluate the influence of WCO qualities on basic properties of rejuvenated asphalts. Then, the rheological properties of rejuvenated asphalt were characterized based on rotational viscometer (RV), dynamic shear rheometer (DSR), and bending beam rheometer (BBR) test results. Further, SARA (saturates, aromatics, resins, and asphaltenes) fraction analysis and Fourier transform infrared spectroscopy (FTIR) tests were performed to investigate the effects of WCO qualities on asphalt chemical composition. Finally, grey correlation coefficients were calculated and the relationships between WCO qualities and rejuvenated asphalt properties were quantitatively evaluated. The experimental results indicated that WCO qualities influence the rejuvenation behaviors of aged asphalt significantly, and the WCO with higher qualities (low acid value and viscosity, as defined in this research) tends to achieve better rejuvenation effects. Based on the results of grey correlation analyses, the acid value is, relatively, a better indicator than viscosity in predicting the rejuvenation efficiency of WCO. The rejuvenation thresholds of WCO are varied with the categories of properties of rejuvenated asphalts, and WCO with an acid value of 0.4–0.7 mg KOH/g, or a viscosity of 140–540 mm2/s, can meet all of the performance requirements for asphalt rejuvenation used in this research.

1 November 2020 in Science of The Total Environment
Verified
Journal Article
Closed access
Xinxing ZhouXinxing Zhou
Xinxing Zhou
TMTaher Baghaee Moghaddam
Taher Baghaee Moghaddam
MCMeizhu Chen
Meizhu Chen
Shaopeng WuShaopeng Wu
Shaopeng Wu
Adhikari SanjeevAdhikari Sanjeev
Adhikari Sanjeev