Wojciech Poćwiardowski

Dr. Wojciech Poćwiardowski

orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 October 2021 in Molecules
Verified
Journal Article
Open access
PDF file
WSWaldemar Studziński
Waldemar Studziński
WPWojciech Poćwiardowski
Wojciech Poćwiardowski
WOWeronika Osińska
Weronika Osińska
During the operation of swimming pools, large losses of water from the backwash of swimming pool filters are observed. This water is often discharged into sewers or used to sprinkle sports grounds. The aim of the research was to design and build an installation for purification and recovery of backwash water (BWW). It consists of flocculation, pre-filtration, and ultrafiltration based on filter tubes and ozone disinfection. Backwash water treatment installation contributes to purification and improvement of water quality. The effectiveness of the removal of microbial contamination with the use of the system was over 99%. The high efficiency of removing physicochemical impurities was also achieved. Water turbidity was reduced from 96.9 NTU to 0.13 NTU. After using the system, the oxidability of water decreased from 6.26 mg O2∙dm−3 to 0.4 mg O2∙dm−3. When using the system, a reduction of total organic carbon by 80% was also noticed. After the treatment process, water meets the strict criteria and can be returned to the pool system of water as fresh water with parameters of supply water—directly to the overflow tank. It has been shown that up to 96% of water can be recovered with the technology. The cost comparison showed annual savings of over EUR 9000.

6 March 2024 in Sustainability
Verified
Journal Article
Open access
PDF file
Piotr KanarekPiotr Kanarek
Piotr Kanarek
BBBarbara Breza-Boruta
Barbara Breza-Boruta
WPWojciech Poćwiardowski
Wojciech Poćwiardowski
JSJoanna Szulc
Joanna Szulc
The reuse of wash water in the agri-food industry is in line with sustainability goals through the reduction of the water footprint. Depending on the production process and raw material type, wash waters may exhibit severe biological and physicochemical contamination. The use of traditional methods of chlorine disinfection of water may be linked to the formation of hazardous by-products. The recycling of contaminated water should be supported by the evaluation of physicochemical and microbiological parameters before and after application of a treatment to validate the process. This study aimed to assess physicochemical and microbiological properties of rinse water from a post-harvest processing plant before and after applying an innovative modular water treatment system. The test material was washing water after apple rinsing obtained from a post-harvest processing plant (Northern Poland). The water recovery system included a wash water tank, a sand pre-filter, an ultrafiltration system, and an ozonation tank. No microorganisms were found in the treated water. The physicochemical properties of the water were also improved: pH, conductivity, turbidity, ammonium ion, bromide, and nitrate content. The results indicate that rinse water from the fruit industry may be effectively purified using the tested purification system and reused in production processes.

4 March 2023 in Environmental Science and Pollution Research
Verified
Journal Article
Open access
PDF file
WPWojciech Poćwiardowski
Wojciech Poćwiardowski
The aim of the research was to check the possibility of using the rinsing water after rinsing the recreational pool filters, cleaned with the rinse water recovery system, for irrigation of green areas. The system consists of the following stages: flocculation, pre-filtration, and ultrafiltration based on filter tubes. The degree of contamination of the rinse waters before and after the treatment process was assessed by means of physicochemical and microbiological tests, and then compared with the permissible parameter values for wastewater discharged into the ground or water. Thanks to the use of flocculation and appropriate ultrafiltration, the high level of total suspended solids and total organic carbon was reduced, which allows for safe discharge of purified water into the environment. Graphical Abstract Circular economy, wash water, zero waste technologies, water footprint, water recycling

14 March 2017
Verified
Journal Article
Open access
CMCelestyna Mila-Kierzenkowska
Celestyna Mila-Kierzenkowska
AWAlina Woźniak
Alina Woźniak
EKEwa Krzyżyńska-Malinowska
Ewa Krzyżyńska-Malinowska
LKLucyna Kałużna
Lucyna Kałużna
Roland WesołowskiRoland Wesołowski
Roland Wesołowski
MOMarcin Owcarz
Marcin Owcarz
Scabies is an ectoparasitic infection, which occurs because of direct skin-to skin contact. The ideal treatment modality is still unclear and further research on this topic is warranted. The aim of the study was to compare the efficacy and safety of the topical scabicides: permethrin, crotamiton and sulfur ointment. Fifty four patients with diagnosed scabies were randomly divided into three treatment groups. The first group received 5% permethrin cream twice with one week interval, the patients from the second group were given crotamiton lotion for two days twice with one week interval, while the third group received 10% sulfur ointment for two or three weeks. All patients were followed up at 1, 2 and 4 weeks intervals. At one-week follow up the cure rate was significantly higher at permethrin-treated group when compared to crotamiton group (P< 0.001) and sulfur group (P< 0.001). At the end of two-week interval, the cure rate at permethrin group was 100%, while at crotamiton group, 66.7% and in sulfur group 38.9% (P< 0.001). At 4-week follow up the applied treatment was effective in all studied individuals. The topical application of permethrin, crotamiton and sulfur was equally efficacious at 4-week follow up, however permethrin cream showed faster improvement at first and second follow up. Acquiring permethrin is considered as expensive option and crotamiton lotion seems to be cost-less alternative to this cream.

30 September 2025 in Water
Verified
Journal Article
Open access
PDF file
WPWojciech Poćwiardowski
Wojciech Poćwiardowski
Filter wash water (FWW) from public swimming pools is a recoverable resource, yet full-scale evidence on safe on-site reuse with documented economics is scarce. We evaluated a full-scale integrated recovery unit (SOWA) installed at an indoor public pool. The SOWA system—sedimentation, granular filtration operated at a hydraulic loading rate (HLR) of 7.5–10 m3 m−2 h−1, ultrafiltration, and chlorine-dioxide (ClO2) disinfection—was monitored for physicochemical and microbiological performance. Turbidity decreased from 23.1 nephelometric turbidity units (NTU) to 0.25 NTU; chemical oxygen demand, reported as the permanganate index (COD_Mn), fell from 10.4 to 1.6 mg O2 L−1; and total microbial count declined from 1.6 × 104 to 30 colony-forming units per millilitre (CFU mL−1). Indicator organisms (Escherichia coli, Intestinal enterococci and Pseudomonas aeruginosa) were not detected, and all quality criteria complied with national standards. At the Olender facility, monthly freshwater use dropped from 1700 to 1000 m3 after 24/7 SOWA operation, while combined chlorine was maintained at 0.12 mg Cl2/L and no issues with chloroform were observed. The unit recovered 4.7 m3 h−1 of FWW for non-potable uses. According to manufacturer catalogue data, the recovery process can reach up to 96%, enabling annual savings up to ~EUR 9000 and a payback of ~2 years under favourable tariffs and loads. Our outcomes are consistent with independent full-scale reuse trains (e.g., ultrafiltration/reverse osmosis) and with disinfection-by-product control strategies reported in the literature, and they align with international guidance for swimming-pool water reuse. This study provides a rare, end-to-end implementation at full scale, documenting continuous operation, verified microbial safety, regulatory compliance, quantified water and cost savings, and site-specific economics for a compact, multi-barrier FBW recovery system that can be directly transferred to similar facilities.

1 January 2023 in Zywnosc Nauka Technologia Jakosc/Food Science Technology Quality
Verified
Journal Article
Closed access
JSJoanna Szulc
Joanna Szulc
KSKatarzyna Skórczewska
Katarzyna Skórczewska
GGGrażyna Gozdecka
Grażyna Gozdecka
WPWojciech Poćwiardowski
Wojciech Poćwiardowski
KLKrzysztof Lewandowski
Krzysztof Lewandowski
BBBłażej Błaszak
Błażej Błaszak
Background. Honey is a popular food product because of its taste, nutritional and health values. It is valued for its rich composition. During storage, honey changes its consistency from liquid to solid. The length of this process varies depending on the botanical origin of honey. The goal of the study was to determine the impact of thermal treatment on the selected qualitative features of honey and to extend the period during which honey remains liquid. The research material was non-purified, raw polyfloral honey. To prevent quick honey crystallization, hot air, microwave radiation and ultrasonic treatment was carried out. In order to identify changes in the structure of honey, its moisture content, hydroxymethylfurfural (HMF) content, the degree of honey crystallization during storage using the measurement of the amount of backscattered light (BS) and thermal properties using differential scanning calorimetry (DSC) were deter mined. Results and conclusions. Each of these treatments was accompanied by an increase in the hydroxy methylfurfural content (HMF). However, the HMF content in heat-treated honey still meets the Council Directive 2001/110/EC criteria (< 40 mg/kg). To measure the progress of honey granulation during stora ge, the amount of backscattered light (BS) was checked. The microwave-heated honey remained in the liquid state for a long time, which was confirmed by a low amount of backscattered light. On the other hand, a common treatment preventing honey granulation, i.e. hot air, was not the most efficient method to prolong the storage time of liquid honey. Moreover, the honey heated with hot air had the highest HMF content and BS amount.