We have designed and fabricated TiN/SiO2/TiN–HfO2-based new metamaterial microstructures as an absorber of the visible wavelength, in the range of 400–700 nm, with exceptionally high absorption efficiency (>96%) for solar energy harvesting purposes and generation of heat upon absorption of electromagnetic energy. The finite element method-based COMSOL Multiphysics software simulations were used to optimize the structural parameters of the microstructures and visualize the electric field and electromagnetic power loss distribution in the structure. An optimized 2D unit cell of the structure consists of a 4 μm × 160 nm TiN base on a glass substrate covered with a 70 nm thick SiO2 film. A periodic structure of TiN straps (each 90 nm thick and 2 μm wide) is deposited over the SiO2. The straps are capped with a 40 nm thick layer of high-temperature dielectric HfO2 with a periodicity of 4 µm. This unit is symmetric along the other dimension and is repeated periodically along the horizontal direction. Similar optimized parameters were used for 7, 10, and 100 µm periodic structures to investigate the effect of grating structure pitch on the absorption of light. Although these microstructures were optimized for the visible light spectrum, they show absorption efficiency of >92% when integrated over a broadband wavelength spectrum ranging from 400 to 1200 nm. The experimental data show excellent agreement with the simulated results. We observe less than 5% difference between experimental and simulated absorption efficiencies for the investigated microstructures. Furthermore, we should emphasize that, to the best of our knowledge, this is the first study to experimentally report the light to heat conversion in metamaterials with micron-range size patterned structures.
We have conducted in situ measurements of the surface plasmons and electrical resistivity of noble metal thin films. We present results for the electrical resistivity of these materials as functions of the angle of incidence for p-polarized light of wavelength λ = 632 nm in the Kretschmann configuration optical system. We observe a significantly lower resistivity (higher conductivity) under resonance conditions for the surface plasmon polaritons. The resistivity data are supported by COMSOL simulations of the evanescent fields associated with the surface plasmons. We discuss the resistivity data in terms of the theoretical models, which suggest that the electrical conductivity of the transition metals is sensitive to Umklapp electron-electron scattering and attractive interactions between free electrons because of the screening of the d-band electrons by the s-band electrons.
We report temperature-dependent optical response measurements of YBa2Cu3O7−δ thin films in the visible spectral range under cryogenic conditions. We observe a sharp increase in transmittance near the superconducting transition temperature (Tc), followed by a saturation of transmittance within a few kelvins below Tc. This increase in transmittance is accompanied by a corresponding decrease in reflectance as the temperature drops below Tc; both quantities track the superconducting phase transition. Changes in transmittance are found to be wavelength dependent, with the maximum variation occurring at 633 nm and minimal at 450 nm. These observations establish a correlation between the variation in optical response and the superconducting phase transition in the visible regime. The results of our experiment highlight the potential for using non-contact optical measurements in the visible range to determine Tc. The effect can be explained using the two-fluid model, which can account for the observed temperature and wavelength dependence of the transmittance of the superconducting thin films.