The paper presents a simulation of the Airbus A350-900 wing-to-fuselage assembly process. The latter is a complex multistage process where the compliant parts are being joined by riveting. The current research analyzes the quality of the temporary fastener arrangement. The fastener arrangement is being checked to ensure that the residual gap between joined parts is small, and the fastener loads closing the gap are calculated. The deviations of the part shape from nominal are modeled via initial gaps. A cloud of initial gaps is generated based on the statistical analysis of the available measurements assuming the stochastic nature of local gap roughness. Through the reduction of the corresponding contact problem to a quadratic programming (QP) problem and the use of efficient QP algorithms together with the task-level parallelism, the mass contact problem solving on refined grids is accomplished.
The paper describes the methodology of contact problem solving that is used in specialized software code aimed at simulation of aircraft assembly process. For considered class of problems it is possible to radically reduce the number of unknowns without loss of accuracy.The results of validation of developed code against physical experiments and commercial FEM codes are also given.
1 January 2014 in Journal of Mathematics in Industry
Purpose: The paper describes the methodology of contact problem solving that is used for simulation of aircraft assembly process. Methods: The dimension of the problem is reduced after eliminating the unknowns outside the contact zone and the initial problem transforms into the problem of quadratic programming with linear constraints. Results: The special computer code ASRP (Assembly Simulation of Riveting Process) was developed on the base of presented methodology. Now this code is utilized by Airbus. Some results of application of developed code are given in this paper.
19 September 2017 in SAE International Journal of Advances and Current Practices in Mobility
The paper is devoted to the simulation of A320 wing assembly on the base of numerical experiments carried out with the help of ASRP software. The main goal is to find fasteners’ configuration with minimal number of fastening elements that provides closing of admissible initial gaps.However, for considered junction type initial gap field is not known a priori though it should be provided as input data for computations. In order to resolve this problem the methodology of random initial gap generation based on available results of gap measurements is developed along with algorithms for optimization of fasteners' configuration on generated initial gaps.Presented paper illustrates how this methodology allows optimizing assembly process for A320 wing.
17 September 2013 in SAE International Journal of Aerospace
The paper is devoted to further development of numerical methods for simulation of riveting process during aircraft assembly (see [3, 4]). Algorithm modifications that increase computation accuracy, speed and complexity are given. These modifications involve the dual problem solving, incorporation of multiple calculation nets and special two stage procedure for calculation of deformations and stresses arising during assembly.