Since most of the cable-driven parallel manipulators (CDPMs) are small in dimension or low in speed, the self-weight or inertia of the cable is neglected when dealing with the problems of kinematics, dynamics and workspace. The cable is treated as a massless straight line, and the inertia of the cable is not discussed. However, the camera robot is a large-span high-speed CDPM. Thus, the self-weight and inertia of the cable cannot be negligible. The curved cable due to the self-weight is modeled as a catenary to accurately account for its sagging effect. Moreover, the dynamic model of the camera robot is derived by decomposing the motion of the cable into an in-plane motion and an out-plane motion, based on which an iterative-based tension distribution algorithm and a workspace generation algorithm are presented. An optimization model is presented to simultaneously improve the workspace volume, anti-wind disturbance ability and impulse of tensions on the camera and pan–tilt device system (CPTDS) by selecting the proper optimal variables under the linear and nonlinear constraints. An improved genetic algorithm (GA) is proposed, and the simulation results demonstrate that the improved GA offers a stronger ability in global optimization compared to the standard genetic algorithm (SGA). The ideal-point method is employed to avoid the subjective influence of the designer when performing the multi-objective optimization, and a remarkable improvement of the performance is obtained through the optimization. Furthermore, the distribution characteristics of the optimization objects are studied, and some valuable conclusions are summarized, which will provide some valuable references in designing large-span high-speed CDPMs.

This paper investigates the vibration bandgap properties of two-dimensional (2D) periodic composite beam frame structures with component defects. Combined with the topological characteristics of the structure, a generalized position coordinate system is proposed, and an assembly method of the stiffness matrix for the virtual full component model is presented. Then the spectral equations of motion of the whole 2D periodic composite beam frame structures and the ones with component defects are established. Compared with the frequency-domain solutions calculated using the finite element method, the accuracy and the feasibility of the spectral element method (SEM) solutions are verified. It can be shown that the SEM is suitable for analyzing the vibration bandgap properties, and the influence of different component defects and their combination on the bandgap characteristics of 2D periodic frame structures is studied. The results show that forbidden gap splitting will occur in the main bandgap of the structure, but the degree of influence varies. The results also show that the influence of component defects on unsymmetrical or irregular positions of the vibration bandgaps of periodic frame structures is greater than the one in symmetrical or regular positions.