The article describes a system of power transmission via fiber-optic cable, which allows the supply of power to sensors and other electronic devices of ultra-low power located in places of mining workings, for which the mandatory requirement is fire safety. The developed system will allow to replace the application of copper conductors. The result of this research is the developed laboratory bench that allows measuring the current and voltage parameters in the photodetector branch. The equivalent generator method has been used, as well as the known circuit laws with two dedicated nodes for an active two-terminal network. When analyzing the literature, the existing scientific achievements, and discoveries in the field of research, an own concept of research has been formed that is different from foreign analogs. During the experiment, the studies have been performed when the photodetector was in the short circuit, idle mode, and connected to a high-resistance load. Based on the results obtained, current-voltage characteristics (CVC) and histograms have been built using a radiation source (laser) with a power of 10 and 30 mW. The parameters and technical characteristics of the irradiated silicon crystal and the radiation source have been given. The obtained electrical power has been determined using the known laws of electrical engineering, including the Ohm law. To process the experimental data, there has been used quadratic interpolation of the function, the results of the root-mean-square approximation, and there has been carried out the regression analysis. Absolute and relative errors have been calculated. The Student coefficient has been determined with a confidence interval of 0.95. Based on the results of the study, the efficiency of the power transmission system has been determined

Using the quasi-classical kinetic theory of dielectric relaxation, in addition to existing methods, fundamental mathematical expressions are built, which make it possible to more strictly consider the effects of the main charge carriers’ (protons’) tunneling on the numerical values of the molecular parameters (activation energy, equilibrium concentration) of protons in HBC. The formulas for calculating the statistically averaged non-stationary quantum transparency of a parabolic potential barrier for protons have been modernized by more stringent consideration of the effects of corrections caused by an external electric field. For the model of a double-symmetric potential well, a generalized nonlinear solution of the quasi-classical kinetic equation of dielectric relaxation in HBC was built. The phenomenological Bucci-Rive formula for thermally stimulated depolarization current density (TSDC) was first investigated, taking into account quantum transparency, for the case of a parabolic potential barrier. The choice of the parabolic shape of the potential barrier allowed, at a theoretical level, for the mathematical model of relaxation polarization to be brought closer to the conditions of the real spatial structure of the crystal potential field, in comparison with the rectangular potential barrier model. It has been found that quantum effects due to proton tunnel transitions significantly affect the mechanism of thermally stimulated depolarization currents in HBC, over a wide temperature range (50–550 K) and external field parameters (0.1–1 MV/m). Generalized solutions of the nonlinear kinetic equation, recorded considering the effects of field parameters on proton tunnel transitions, made it possible to significantly approximate the theoretical values of activation energies, equilibrium concentrations of protons and amplitudes of the theoretical maxima of the current density of thermally stimulated depolarization, according to their experimental values in the field of low-temperature (50–100 K) and high-temperature (350–550 K) maxima of TSDC density in HBC. For the first time, precision measurements of TSDC temperature spectra were carried out for chalcanthite crystals. The effects of alloying impurities concentrations and crystal calcination temperatures on the parameters of experimental maxima in the TSDC spectrum of chalcanthite were established. A physical mechanism of the quantum tunnel motion of protons in HBC with a complex crystal structure (crystalline hydrates, layered silicates, ferroelectric HBC (KDP, DKDP)) is described. The patterns found in this article indicate a fairly high degree of applied scientific significance for the obtained theoretical results, allowing for the further development of electrophysics and optoelectronics of heterogeneous structures (MIS, MSM) based on proton semiconductors and dielectrics (PSD) and their composites.

This article studies the influence of solid-phase (type 1 samples) and melt-quenching (type 2 samples) technological modes of obtaining Na₃Fe₂(PO₄)₃ polycrystals on their structures and ion-conducting properties. α-Na₃Fe₂(PO₄)₃ polycrystals of the 1st type are formed predominantly under an isothermal firing regime, and the synthesis of the 2nd type is carried out under sharp temperature gradient conditions, contributing to the formation of glassy precursors possessing a reactive and deformed structure, in which the crystallization of crystallites occurs faster than in precursors obtained under isothermal firing. The elemental composition of α-Na₃Fe₂(PO₄)₃ type 2 polycrystals is maintained within the normal range despite the sharp non-equilibrium thermodynamic conditions of synthesis. The microstructure of the type 1 Na₃Fe₂(PO₄)₃ polycrystals is dominated by chaotically arranged crystallites of medium (7–10 μm) and large (15–35 μm) sizes, while the polycrystals of type 2 are characterized by the preferential formation of small (3–4 μm) and medium (7–10 μm) crystallites, causing uniaxial deformations in their structure, which contribute to a partial increase in their symmetry. The advantage of type 2 polycrystals is that they have higher density and conductivity and are synthesized faster than type 1 samples by a factor of 4. The article also considers the issues of crystallization in a solid-phase precursor from the classical point of view, i.e., the process of the formation of small solid-phase nuclei in the metastable phase and their growth to large particles due to association with small crystallites using phase transitions. Possible variants and models of crystallite growth in Na₃Fe₂(PO₄)₃ polycrystals, as well as distinctive features of crystallization between two types of samples, are discussed.

In this paper influence of the excess Ca and Cu cations on the critical temperature (Tc) and critical transport current density (J_c) of high-temperature superconducting ceramics of the compositions (HTSC) Bi_1.6Pb_0.4Sr₂Ca_2.1Cu_3.1O_y, Bi_1.6Pb_0.4Sr₂Ca_2.25Cu_3.25O_y and Bi_1.6Pb_0.4Sr₂Ca₃Cu₄O_y synthesized by the glass-ceramic method has been studied. The synthesis of superconducting ceramics was carried out on the basis of the glass phase, obtained by ultra-fast quenching of the melt. Melting of the mixture of starting components was carried out without the use of a crucible under the influence of IR radiant heating. Analysis of the elemental composition of the samples of the initial precursors showed a significant deviation from stoichiometry in oxygen (increase), as well as a decrease in calcium content. The synthesis of HTSC ceramics was carried out at a temperature of 849–850 °C for 96 h with intermediate grinding every 24 h. Studies of the phase composition of ceramic samples by X-ray diffraction have shown that HTSC ceramics consist only of a superconducting high-temperature phase Bi-2223. Studies of current-carrying characteristics by the four-point probe method according to the criterion of 1 µV/cm² have shown that high-temperature superconducting ceramics of the compositions Bi_1.6Pb_0.4Sr₂Ca_2.1Cu_3.1O_y, Bi_1.6Pb_0.4Sr₂Ca_2.25Cu_3.25O_y and Bi_1.6Pb_0.4Sr₂Ca₃Cu₄O_y have an increased density of critical transport current of 9.12 A/cm², 7.62 A/cm² and 7.26 A/cm², respectively. At the same time, it was found that with a decrease in the content of Ca and Cu cations in HTSC ceramics, an increase in the critical current density is observed.

Nonlinear optical effects in optical waveguides play an important role in the development of fiber and integrated optics systems for optical communication and information processing. On the one hand, nonlinear effects impose restrictions on the radiation power that can be transmitted through an optical fiber or light guide. In this paper, the problem of the occurrence of the phenomenon from the stimulated Brillouin scattering (SBS) effect is investigated using two optical sources of rays in a single-mode optical fiber at joint waves of 1310 nm and 1550 nm. Due to the fact that in all trunk fiber-optic lines, the intensity and energy of input signals is limited due to the influence of SBS, methods are currently being sought to reduce the influence of this phenomenon. It was found that the energy of the input beam in the combined propagation of the compound did not reach the value of the threshold of SBS in the values of 25 dBm and 27 dBm due to the discrepancy between the experimental results and the results of the model. The SBS effect was not observed when the threshold threshold of 15 dBm and 27 dBm – SBS was reached when combining a dual beam along a single optical fiber in one direction. As a result, by double integration, the value of the SBS threshold was raised, and the direction for future scientific research was determined. If the possibility of increasing the threshold of SBS is proved, then increasing the distance of amplifiers in the main networks, respectively, its economic effect increases. In addition, it can be noted that there are no scientific papers devoted to the study of the effects of optical nonlinear effects by combining and distributing these two compounds along a single optical fiber. This article discusses the issues of improving the capacity and determination of the threshold for stimulated Brillouin scattering. To increase the power threshold is invited to consider the dependence of the phase modulation frequency of the spectral width of the laser radiation. In addition, the fact that the SBS threshold did not reach the value at an energy of 27 DB in the case of the double-beam distribution can be proved by discrepancies in comparison with the results of experimental studies and the results of the model that determines the SBS effect

The work is devoted to the description of the development of compression algorithms for hyperspectral aerospace images based on discrete orthogonal transformations for the purpose of subsequent compression in Earth remote sensing systems. As compression algorithms necessary to reduce the amount of transmitted information, it is proposed to use the developed compression methods based on Walsh-Hadamard transformations and discrete-cosine transformation. The paper considers a methodology for developing lossy and high-quality compression algorithms during recovery of 85 % or more, taking into account which an adaptive algorithm for compressing hyperspectral AI and the generated quantization table have been developed. The existing solutions to the lossless compression problem for hyperspectral aerospace images are analyzed. Based on them, a compression algorithm is proposed taking into account inter-channel correlation and the Walsh-Hadamard transformation, characterized by data transformation with a decrease in the range of the initial values by forming a set of channel groups [10–15] with high intra-group correlation [0.9–1] of the corresponding pairs with the selection of optimal parameters. The results obtained in the course of the research allow us to determine the optimal parameters for compression: the results of the compression ratio indicators were improved by more than 30 % with an increase in the size of the parameter channels. This is due to the fact that the more values to be converted, the fewer bits are required to store them. The best values of the compression ratio [8–12] are achieved by choosing the number of channels in an ordered group with high correlation.