γ-Fe2O3@SiO2–CaO NPs were designed. They show predicable and effective magnetic hyperthermia properties in clinically relevant conditions and promote hydroxyapatite growth in SBF. They could be used to heal bone defects due to tumor resection.
Multifunctional substitutes for bone tissue engineering have gained significant interest in recent years in the aim to address the clinical challenge of treating large bone defects resulting from surgical procedures. Sol–gel mesoporous bioactive glass nanoparticles (MBGNs) have emerged as a promising solution due to their high reactivity and versatility. The effect of calcium content on MBGNs textural properties is well known. However, the relationship between their composition, textural properties, and reactivity has not yet been thoroughly discussed in existing studies, leading to divergent conclusions. In this study, pristine and copper-doped binary MGBNs were synthesized by a modified Stöber method, using a cationic surfactant as pore-templating agent. An opposite evolution between calcium content (12–26 wt%) and specific surface area (909–208 m2/g) was evidenced, while copper introduction (8.8 wt%) did not strongly affect the textural properties. In vitro bioactivity assessments conducted in simulated body fluid (SBF) revealed that the kinetics of hydroxyapatite (HAp) crystallization are mainly influenced by the specific surface area, while the composition primarily controls the quantity of calcium phosphate produced. The MBGNs exhibited a good bioactivity within 3 h, while Cu-MBGNs showed HAp crystallization after 48 h, along with a controlled copper release (up to 84 ppm at a concentration of 1 mg/mL). This comprehensive understanding of the interplay between composition, textural properties, and bioactivity, offers insights for the design of tailored MBGNs for bone tissue regeneration with additional biological and antibacterial effects.
18 February 2026 in Advanced Engineering Materials
Polycrystalline α-alumina / yttrium-aluminum garnet (YAG) fibers were prepared from aqueous solutions of aluminum formoacetate and yttrium acetate, with α-Al 2 O 3 nanoparticles as a seeding material. α-Al 2 O 3 /YAG fiber production was achieved via dry-spinning, using polyvinylpyrrolidone as a spinning aid, followed by calcination and sintering of as-spun fibers at various temperature, dwell time and heating ramp. X-ray diffraction analysis evidenced the formation of transitional Al 2 O 3 and yttrium-aluminum perovskite (YAP) phases (1000-1300 °C) before a full conversion to α-Al 2 O 3 / YAG (76 / 24 wt%) at 1500 °C. Full densification required temperatures of at least 1400-1500 °C with a sufficient dwell time (30 min), while increasing sintering temperature induced grain growth. Depending on the thermal treatment, tensile strength and creep factor m of the related fibers could be tailored, either to higher strength at 1400 °C (up to 1149 MPa, m = 0.57) or higher creep at 1500 °C (up to 906 MPa, m = 0.69).