Yaxun Zhang

Dr. Yaxun Zhang


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 April 2014 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
YZYaxun Zhang
Yaxun Zhang
AZAi Zhou
Ai Zhou
BQBoyang Qin
Boyang Qin
QXQuan Xu
Quan Xu
ZLZhihai Liu
Zhihai Liu
LYLibo Yuan
Libo Yuan
We propose a simultaneous temperature and curvature sensor based on a hollow annular core fiber (HACF) Mach-Zehnder interferometer (MZI). The MZI is fabricated by inserting a short section of HACF between two short pieces of multimode fibers, and interference occurs between the light beams transmitting along the air hole and annular core of the HACF. Curvature and temperature can be measured through fringe visibility variation and wavelength shift of the interference spectrum, respectively. The experimental results show that the temperature sensitivity is 30 pm/°C in the range of 30°C-100°C, and the maximum visibility variation is 32.4 dB from 0.555 to 5.405 m -1 . In addition, the device is insensitive to external refractive index.

17 March 2014 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
YZYaxun Zhang
Yaxun Zhang
AZAi Zhou
Ai Zhou
BQBoyang Qin
Boyang Qin
HDHongchang Deng
Hongchang Deng
ZLZhihai Liu
Zhihai Liu
LYLibo Yuan
Libo Yuan
We present a theoretical and experimental investigation on refractive index (RI) sensing characteristics of single mode fiber (SMF) based modal interferometers. Theoretical analysis reveals that interference between different modes in an SMF has a quite different response to the RI variation of the external medium. The interference between the core and lower order cladding modes has negative RI sensitivity whereas that between the core and higher order modes, or between two different order cladding modes have positive sensitivity. A single-mode-multimode-single-mode (SMS) fiber Michelson interferometer with a large-core step-index multimode fiber (MMF) is employed for experimental verification. In the SMS-based Michelson interferometer, the MMF acts as a mode coupler to excite cladding modes in the SMF. The RI response of the SMS-based structures with two different lengths of MMF are respectively tested in sodium-chloride water solutions. Experimental results show excellent agreements with the theoretical analysis.

31 May 2019 in Optics Letters
Verified
Journal Article
Closed access
PDF file
ZLZhihai Liu
Zhihai Liu
MZMin Zhang
Min Zhang
Yu ZhangYu Zhang
Yu Zhang
YZYaxun Zhang
Yaxun Zhang
KLKeqiang Liu
Keqiang Liu
LYLibo Yuan
Libo Yuan
We select a section of spider egg sac silk (SESS) from an Araneus ventricosus for humidity sensing. SESSs are composed of tubiliform fibers, which suggests that the silk fibroin is more sensitive to ambient humidity. We employ a section of single mode fiber (SMF) and a section of SESS to configure an interference-cavity structure. The change of ambient humidity will cause a change in the SESS diameter, which will change the length of the interference-cavity. The change of the interference-cavity length will cause the interference spectrum to redshift, and the SESS-based sensor will perform the humidity-sensing characteristic. The testing results indicate that the higher the ambient humidity, the higher the sensitivity. The maximum value of the sensitivity is 0.99 nm/%RH in the humidity range of 90%–99%. The sensor is protected from temperature disturbance, and the temperature sensitivity is 33 pm/°C. Spider silk is a kind of natural moisture-sensitive material, which is environmentally friendly and does not demand additional sensitization. Therefore, the spider silk is very promising candidates for optical-based chemical and biological sensors that are biocompatible, biodegradable, and highly sensitive.

17 October 2019 in Optics Letters
Verified
Journal Article
Closed access
PDF file
XTXiaoyun Tang
Xiaoyun Tang
Yu ZhangYu Zhang
Yu Zhang
WSWenjie Su
Wenjie Su
YZYaxun Zhang
Yaxun Zhang
ZLZhihai Liu
Zhihai Liu
LYLibo Yuan
Libo Yuan
We propose and demonstrate a simple approach for noncontact, three-dimensional, and stable trapping of a single nanoparticle with a super-low incident laser power (0.7 mW) via the single-fiber optical tweezers. We splice a section of single-mode fiber and a section of multimode fiber to construct a Bessel-like beam, which produces narrow output laser beams. We integrate a high-refractive-index glass microsphere on the tip of the multimode fiber to focus the narrow output laser beams. The focused beams provide a nanoscale optical trap for a single nanoparticle (polystyrene sphere, diameter of 200 nm). This optical fiber probe has the advantages of high laser transmission efficiency, high spatial resolution, and minimum joule heating. The proposed approach extends the application potential of fiber-based optical manipulations, such as nanoparticle sorting, single-cell organelle analysis, and bio-sensing.

25 September 2018 in Physical Review Letters
Verified
Journal Article
Closed access
PDF file
YZYu Zhang
Yu Zhang
YZYaxun Zhang
Yaxun Zhang
ZLZhihai Liu
Zhihai Liu
XTXiaoyun Tang
Xiaoyun Tang
XYXinghua Yang
Xinghua Yang
LYLibo Yuan
Libo Yuan
We demonstrate a new principle of the laser-induced hammer-hit vibration of a micron-sized black sphere in liquid glycerol with a single divergent Gaussian beam. The light-induced Δα-photophoretic force, which is significantly improved by the vibrating speed of the microparticle, is responsible for both the pushing and pulling force of the hammer-hit vibration. Our approach expands the optical manipulation of microparticle hammer-hit vibration to a liquid medium and provides full control over the trapped particles, including the adjustment of the vibration frequency, amplitude, and position.

11 January 2022 in IEEE Sensors Journal
Verified
Journal Article
Closed access
YZYaxun Zhang
Yaxun Zhang
JXJiajun Xue
Jiajun Xue
WLWei Liu
Wei Liu
Yu ZhangYu Zhang
Yu Zhang
SLSong Li
Song Li
LYLibo Yuan
Libo Yuan
We propose and demonstrate a cascaded dual-channel fiber surface plasmon resonance (SPR) sensor based on a phase change material, Ge 2 Sb 2 Te 5 (GST). This material may modulate the sensing bands of SPR to the infrared bands. We configure channel I with a 50 nm Au film and configure channel II with a 50 nm Au film and a 30 nm GST film. The experimental results show that the sensing bands of channel I are 596 nm - 793 nm, and the refractive index (RI) sensitivity is 2781 nm/RIU. The sensing bands of channel II are 1045 nm - 1421 nm, and the RI sensitivity reaches 5226 nm/RIU. The RI measuring range is 1.333 - 1.403. The sensing bands of the two channels are completely separated. We coat polydimethylsiloxane (PDMS) on the surface of Au-GST film. Since PDMS is a heat-sensitive material with a high thermo-optical coefficient (TOC), channel II responds to temperature. Therefore, the sensor can also be used to measure the TOC of unknown liquid samples. The temperature sensitivity reaches 5.88 nm/°C. The sensor has high sensitivity, high resolution, good stability, and strong toughness. These advantages meet the requirements of biochemistry for high-precision and harsh experimental environments. We believe that the sensor has bright application prospects.