Ramadan Aliti

Dr. Ramadan Aliti

orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 January 2024 in Heliyon
Verified
Journal Article
Open access
RARamadan Aliti
Ramadan Aliti
YPY. Putthisigamany
Y. Putthisigamany
PCP. Chelvanathan
P. Chelvanathan
MRMimoza M. Ristova
Mimoza M. Ristova
In this paper, we examine the impact of the precursor's mixing temperature and mixing protocol on the crystal structure and morphological and optical properties of Cu2ZnSnS4 (CZTS) thin films. Four samples of CZTS thin films were synthesized with the sol-gel spin coating technique by previously mixing precursors at (a) 150 °C and (b) room temperature (RT), either (i) all at once or (ii) through sequential adding the individual chemicals 30 min apart. SEM-EDX, XRD, Raman and Visible spectroscopy analysis showed that sample 150°C-ST (chemicals mixed at the same time at 150 °C) fulfilled all the theoretical stoichiometric criteria (poor in Cu, rich in Zn) for the high-quality CZTS absorbers. The larger grain size (850 nm) and crystallite size (73.96 nm), lower strain (0.49×10−3) and band gap Eg=1.44eV which is closest to the Shockley–Queisser limit for single junction solar cells (1.34 eV).

1 December 2021 in International Journal of Islamic Thought
Verified
Journal Article
Closed access
RARamadan Aliti
Ramadan Aliti

30 September 2023 in Buildings
Verified
Journal Article
Open access
PDF file
Anxhelina MyftaragoAnxhelina Myftarago
Anxhelina Myftarago
TBThomas A. Bier
Thomas A. Bier
EQElsa Qoku
Elsa Qoku
RARamadan Aliti
Ramadan Aliti
MZMilazim Zogaj
Milazim Zogaj
This study investigates the influence of various factors on the performance of ternary binders, utilizing statistical approaches. The research focuses on the influence of varying compositions of Portland Cement-Calcium Aluminate Cement-Calcium Sulphate (PC-CAC-CŜ), types and amounts of mineral powders, and chemical admixtures in ternary binders. Using the Taguchi design, the study required a limited number of experimental trials, utilizing a standard orthogonal array of seven factors across three levels. These factors encompassed binder composition (C1-C2-C3), mineral powder types (limestone, quartz, slag), replacement ratio (0%, 25%, 50%), retarder (0%, 0.1%, 0.2%), superplasticizer, viscosity modifying agent (stabilizer) and accelerator (0%, 0.05%, 0.1%). Measurements on hydration kinetics, dimensional stability, compressive strength, and microstructural analyses like X-ray diffraction were conducted. Principal Component Analysis (PCA) was employed to interpret the continuous data derived from heat of hydration curves, length change curves and X-ray diffraction (XRD) patterns. Results indicated that retarder quantity and binder type significantly impacted paste workability. Higher powder content led to reduced strength, whereas increased accelerator improved strength. A strong correlation was observed between accelerator content and the dimensional stability. The primary hydration product’s formation was predominantly influenced by the PC-CAC-CŜ ratio, accelerator, and cement substitutions.

10 October 2024 in JNSM - Journal of Natural Sciences and Mathematics of UT
Verified
Journal Article
Open access
RARamadan Aliti
Ramadan Aliti
YPYoganash Putthisigamany
Yoganash Putthisigamany
MRMimoza Ristova
Mimoza Ristova
In this work we present а comparative study of two photovoltaic cells based on n-type CZTS (Cu2ZnSnS4) kesterite-type thin films, using (a) an undoped pristine CZTS absorber and (b) doped with Li CZTS absorber, both integrated into photovoltaic (PV) cells, incorporating CdS thin film as an n-type buffer layer. The morphological, structural, compositional, optical, and electrical properties of both absorbers CZTS and CZTS:Li were studied by SEM-EDX, XRD, Vis-NIR spectroscopy, Hall-effect, and four-point probe measurements, revealing the impact on the Li-doping. The evaluation of the band gap was made using Tauc-plots. The influence of Li-doping in the CZTS films was scrutinized through the comparative study of the IV characteristics of PV cells. The results showed that the Li-doped CZTS yields better efficiency η=0,83% versus 0,53% for pristine CZTS absorber and better cell parameters, except for the Fill-Factor.

23 August 2025 in Journal of Materials Science: Materials in Electronics
Verified
Journal Article
Closed access
PDF file
RARamadan Aliti
Ramadan Aliti
YPYoganash Putthisigamany
Yoganash Putthisigamany
PCPuvaneswaran Chelvanathan
Puvaneswaran Chelvanathan
MRMimoza M. Ristova
Mimoza M. Ristova