Cadmium stress is a major threat to plant growth and survival worldwide. The current study aims to green synthesis, characterization, and application of zinc-oxide nanoparticles to alleviate cadmium stress in maize (Zea mays L.) plants. In this experiment, two cadmium levels (0, 0.6 mM) were applied to check the impact on plant growth attributes, chlorophyll contents, and concentration of various primary metabolites and antioxidants under exogenous treatment of zinc-oxide nanoparticles (25 and 50 mg L^-1) in maize seedlings. Tissue sampling was made 21 days after the zinc-oxide nanoparticles application. Our results showed that applying cadmium significantly reduced total chlorophyll and carotenoid contents by 52.87% and 23.31% compared to non-stress. In comparison, it was increased by 53.23%, 68.49% and 9.73%, 37.53% with zinc-oxide nanoparticles 25, 50 mg L^-1 application compared with cadmium stress conditions, respectively. At the same time, proline, superoxide dismutase, peroxidase, catalase, and ascorbate peroxidase contents were enhanced in plants treated with cadmium compared to non-treated plants with no foliar application, while it was increased by 12.99 and 23.09%, 23.52 and 35.12%, 27.53 and 36.43%, 14.19 and 24.46%, 14.64 and 37.68% by applying 25 and 50 mg L^-1 of zinc-oxide nanoparticles dosages, respectively. In addition, cadmium toxicity also enhanced stress indicators such as malondialdehyde, hydrogen peroxide, and non-enzymatic antioxidants in plant leaves. Overall, the exogenous application of zinc-oxide nanoparticles (25 and 50 mg L^-1) significantly alleviated cadmium toxicity in maize. It provides the first evidence that zinc-oxide nanoparticles 25 ~ 50 mg L^-1 can be a candidate agricultural strategy for mitigating cadmium stress in cadmium-polluted soils for safe agriculture practice.

Tryptophan, as a signal molecule, mediates many biotic and environmental stress-induced physiological responses in plants. Therefore, an experiment was conducted to evaluate the effect of tryptophan seed treatment in response to cadmium stress (0, 0.15, and 0.25 mM) in sunflower plants. Different growth and biochemical parameters were determined to compare the efficiency of the treatment agent. The results showed that cadmium stress reduced the growth attributes, including root and shoot length, dry and fresh weight, rate of seed germination, and the number of leaves. Cadmium stress also significantly reduced the contents of chlorophyll a, b, and total chlorophyll, carotenoid contents, phenolics, flavonoids, anthocyanin, and ascorbic acid. Whereas cadmium stress (0.15 and 0.25 mM) enhanced the concentrations of malondialdehyde (45.24% and 53.06%), hydrogen peroxide (−11.07% and 5.86%), and soluble sugars (28.05% and 50.34%) compared to the control. Tryptophan treatment decreased the effect of Cd stress by minimizing lipid peroxidation. Seed treatment with tryptophan under cadmium stress improved the root (19.40%) and shoot length (38.14%), root (41.90%) and shoot fresh weight (13.58%), seed germination ability (13.79%), average leaf area (24.07%), chlorophyll b (51.35%), total chlorophyll (20.04%), carotenoids (43.37%), total phenolic (1.47%), flavonoids (19.02%), anthocyanin (26.57%), ascorbic acid (4%), and total soluble proteins (12.32%) compared with control conditions. Overall, the tryptophan seed treatment showed positive effects on sunflower plants’ growth and stress tolerance, highlighting its potential as a sustainable approach to improve crop performance.

Brassinolides (BRs) are naturally-occurring phytohormones, which are essentially important to improve the crop adoptive capacity to various stresses. Spray volume (SV) and agrochemical application methods are associated with chemical deposition and field efficiency. The objective of this study was to compare the possible effects of 28-Homobrassinolide (HBL) dosages 18, 22, and 30 mg a.i. ha⁻¹ for unmanned aerial vehicle (UAV) sprayers (15 L ha⁻¹ and 30 L ha⁻¹) and 22 mg a.i. ha⁻¹ for Knapsack manual sprayers (KMS) (450 L ha⁻¹) at maize silking stage on droplets deposition distribution, photosynthetic parameters, grain filling process and yield. The results showed that the droplet deposition of UAV (15, 30 L ha⁻¹) was 47.04%, 8.89% higher than KMS. However, the UAV sprayer had a poor droplet deposition distribution. HBL significantly increased the photosynthetic parameters, grain filling rate, and yield. A UAV spray volume of 15 L ha⁻¹ with 22 mg a.i. ha⁻¹ significantly increased grains yield by 4.16–5.64%, 7.5–12.09% compared to KMS and CK in both years. Considering the high efficiency of the UAV sprayer and better effects of HBL on final yield, spraying 22~30 mg a.i. ha⁻¹ with UAV spray volume 15 L ha⁻¹ at the silking stage could be a better strategy.

Exogenously applied phytohormones improve the endosperm cells and establish greater kernel sink capacity and grain filling, improving grain yield. In this study, 28-Homobrassinolide (HBR) dosages (20, 25, and 30 mg a. i. ha⁻¹) were applied separately at the silking stage under controlled conditions, and EDAH (a mixture of ethephon and diethyl aminoethyl hexanoate) dosage of 90 g a. i. ha⁻¹ was sprayed at the jointing stage to enhance the lodging resistance. Our objective was to investigate whether the application of HBR under controlled conditions or with EDAH could enhance the grain filling rate by regulating endogenous hormones. The results showed that HBR at the silking stage significantly increased endogenous hormones (ABA, IAA, Z+ZR), hampered leaf senescence, enhanced photosynthetic, improved dry matter accumulation in grains, and increased the grain-filling period, filling rate, and thousand-grains weight. Additionally, HBR 25 and 30 mg a. i. ha⁻¹ increased the final yield by 9.9% and 19.5% compared to the control (CK) in 2020 and 14.1% and 18.95% in 2021, respectively. There was no significant difference between the results obtained from HBR-controlled and EDAH treatments at the jointing stage. Thus, we conclude that spraying HBR 25~30 mg a. i. ha⁻¹ under controlled conditions may increase the grain yield under normal weather conditions. In adverse weather conditions and heavy wind, spraying EDAH 90 g a. i. ha⁻¹ at the jointing stage and HBR 30 mg a. i. ha⁻¹ at the silking stage can enhance maize production.