In this work, a low-cost and rapid electrochemical resistive DNA biosensor based on the current relaxation method is described. A DNA probe, complementary to the specific human papillomavirus type 16 (HPV-16) sequence, was immobilized onto a screen-printed gold electrode. DNA hybridization was detected by applying a potential step of 30 mV to the system, composed of an external capacitor and the modified electrode DNA/gold, for 750 µs and then relaxed back to the OCP, at which point the voltage and current discharging curves are registered for 25 ms. From the discharging curves, the potential and current relaxation were evaluated, and by using Ohm’s law, the charge transfer resistance through the DNA-modified electrode was calculated. The presence of a complementary sequence was detected by the change in resistance when the ssDNA is transformed in dsDNA due to the hybridization event. The target DNA concentration was detected in the range of 5 to 20 nM. The results showed a good fit to the regression equation $\mathsf{\Delta }{R}_{total}\left(\mathsf{\Omega }\right)=2.99 \times \left[\mathrm{DNA}\right]+81.55$, and a detection limit of 2.39 nM was obtained. As the sensing approach uses a direct current, the electronic architecture of the biosensor is simple and allows for the separation of faradic and nonfaradaic contributions. The simple electrochemical resistive biosensor reported here is a good candidate for the point-of-care diagnosis of HPV at a low cost and in a short detection time.

DNA electrochemical biosensors represent a feasible alternative for the diagnosis of different pathologies. In this work, the development of an electrochemical method for Human Papillomavirus-16 (HPV-16) sensing is reported based on potential relaxation measurements related to the discharge of a complex double layer of a DNA-modified gold electrode. The method used allows us to propose an equivalent circuit (EC) for a DNA/Au electrode, which was corroborated by electrochemical impedance spectroscopy (EIS) measurement. This model differs from the Randles circuit that is commonly used in double-layer simulations. The change in the potential relaxation and associated charge transfer resistance were used for sensing the DNA hybridization by using the redox pair Fe(CN)₆^4-/Fe(CN)₆³⁺ as an electrochemical indicator. In order to determinate only the potential relaxation of the composed double layer, the faradic and double-layer current contributions were separated using a rectifier diode arrangement. A detection limit of 0.38 nM was obtained for the target HPV-16 DNA sequences. The biosensor showed a qualitative discrimination between a single-base mismatched sequence and the fully complementary HPV-16 DNA target. The results indicate that the discharge of the double-layer detection method can be used to develop an HPV DNA biosensor.

Among all cancers, lung cancer is the one with the highest mortality rate, and it also has limited therapeutics. Antitumor agents based on medicinal plants have gained importance as a source of bioactive substances. Tagetes erecta is a plant of great cultural value, and recent reports have suggested its cytotoxic effects in tumor cells. Our objective was to evaluate the antitumor activity of Tagetes erecta extract in a lung carcinoma model. Hydroalcoholic extracts were obtained from fresh flowers and leaves of T. erecta; both extracts did not exert toxicity on Artemia salina. We observed cytotoxic effects induced by the floral extract in Lewis lung carcinoma (LLC) and breast tumor cell line (MCF7), but not by the leaf extract. In vivo, a xenograft lung carcinoma model was performed with LLC cells implanted on C57BL/6 mice, which showed that the floral extract reduced tumor growth and improved the effect of etoposide. Microscopic analysis of tumors showed a reduction in mitoses and an increase in necrotic areas with the extract and the etoposide. The main phytochemical compounds found are 2,3-dihydro-benzofuran, octadecanoic acid, benzenacetic acid, oleic acid, linoleic acid, and acetic acid. We conclude that the hydroalcoholic extract of T. erecta flowers has cytotoxic effects in lung carcinoma cells and enhances the effect of etoposide.

Mixed oxide Ir-Sn-Sb-O electrocatalyst was synthesized using thermal decomposition from chloride precursors in ethanol. Our previous results showed that Ir-Sn-Sb-O possesses electrocatalytic activity for an oxygen evolution reaction (OER) in acidic media. In the present work, the physicochemical characterization and performance of Ir-Sn-Sb-O in an electrolysis cell are reported. IrO₂ supported on antimony doped tin oxide (ATO) was also considered in this study as a reference catalyst. Scanning electron microscopy (SEM) images indicated that Ir-Sn-Sb-O has a mixed morphology with nanometric size. Energy dispersive X-ray spectroscopy (EDS) showed a heterogeneous atomic distribution. Transmission electron microscopy (TEM) analysis resulted in particle sizes of IrO₂ and ATO between 3 to >10 nm, while the Ir-Sn-Sb-O catalyst presented non-uniform particle sizes from 3 to 50 nm. X-ray diffraction (XRD) measurements indicated that synthesized mixed oxide consists of IrO₂, IrO_x, doped SnO₂ phases and metallic Ir. The Ir-Sn-Sb-O mixed composition was corroborated by temperature programmed reduction (TPR) measurements. The performance of Ir-Sn-Sb-O in a single cell electrolyser showed better results for hydrogen production than IrO₂/ATO using a mechanical mixture. Ir-Sn-Sb-O demonstrated an onset potential for water electrolysis close to 1.45 V on Ir-Sn-Sb-O and a current density near to 260 mA mg⁻¹ at 1.8 V. The results suggest that the mixed oxide Ir-Sn-Sb-O has favorable properties for further applications in water electrolysers.

During the last decades, most bacterial strains have become increasingly resistant to antibiotics. This led the WHO to declare a global emergency in 2017 and urge the development of new active compounds. Some families of antibiotics still show high antibacterial efficacy, as is the case of fluoroquinolones, which have a broad spectrum of action. For this reason, our research group derived several compounds from fluoroquinolones, selecting a compound with good antibacterial activity for further evaluations, a difluoroboranil-fluoroquinolone complex labeled 7a. Antibacterial activity was evaluated using the Kirby–Bauer method against S. aureus (clinical isolate HGZ2201#ID). The MIC and MBC were obtained by macrodilutions and reseeding. In vivo antimicrobial activity was evaluated in a Balb/c mouse model infected intratracheally with S. aureus and subsequently treated with ciprofloxacin or 7a (80 mg/kg/day) for five days. A mean of 8.55 ± 0.395 cm² inhibition area was observed using 7a, while ciprofloxacin generated a mean inhibition of 7.86 ± 0.231 cm². Compound 7a showed a MIC and MBC of 0.25 μg/mL. This reduced the generation of pneumonic lung tissue to 5.83%, while the untreated infected group generated 60.51% of pneumonic tissue. Compound 7a proved to be an antimicrobial agent capable of inhibiting the in vitro development of S. aureus. Furthermore, 7a showed effectiveness in decreasing the progression of acute pneumonia induced by S. aureus in a murine model.

An efficient immobilization of Glucose oxidase (GOx) on an appropriate substrate is one of the main challenges of developing fuel cells that allow energy to be obtained from renewable substrates such as carbohydrates in physiological environments. The research importance of biofuel cells relies on their experimental robustness and high compatibility with biological organisms such as tissues or the bloodstream with the aim of obtaining electrical energy even from living systems. In this work, we report the use of 5,10,15,20 tetrakis (1-methyl-4-pyridinium) porphyrin and glutathione capped CdTe Quantum dots (GSH-CdTeQD) as a support matrix for the immobilization of GOx on carbon surfaces. Fluorescent GSH-CdTeQD particles were synthesized and their characterization by UV-Vis spectrophotometry showed a particle size between 5–7 nm, which was confirmed by DLS and TEM measurements. Graphite and Toray paper electrodes were modified by a drop coating of porphyrin, GSH-CdTeQD and GOx, and their electrochemical activity toward glucose oxidation was evaluated by cyclic voltammetry, chronoamperometry and electrochemical impedance spectroscopy. Additionally, GOx modified electrode activity was explored by scanning electrochemical microscopy, finding that near to 70% of the surface was covered with active enzyme. The modified electrodes showed a glucose sensitivity of 0.58 ± 0.01 μA/mM and an apparent Michaelis constant of 7.8 mM. The addition of BSA blocking protein maintained the current response of common interferent molecules such as ascorbic acid (AA) with less than a 5% of interference percentage. Finally, the complex electrodes were employed as anodes in a microfluidic biofuel cell (μBFC) in order to evaluate the performance in energy production. The enzymatic anodes used in the μBFC allowed us to obtain a current density of 7.53 mAcm⁻² at the maximum power density of 2.30 mWcm⁻²; an open circuit potential of 0.57 V was observed in the biofuel cell. The results obtained suggest that the support matrix porphyrin and GSH-CdTeQD is appropriate to immobilize GOx while preserving the enzyme’s catalytic activity. The reported electrode arrangement is a viable option for bioenergy production and/or glucose quantification.