Kotel'nikov Institute of Radioengineering and Electronics of Russian Academy of Sciences The results of experimental studies on spin current at the interface of iridate/manganite heterostructure SrIrO3/La0.7Sr0.3MnO3 consisted of oxide epitaxial films with nanometer thickness are presented. A pure spin current was induced by microwave irradiation in GHz frequency band under conditions of ferromagnetic resonance. The spin current was detected due to inverse spin-Hall effect measuring the spectral characteristics of charge current arising on electrically conductive SrIrO3 film with strong spin-orbit interaction. The spin-Hall angle, which characterizes the efficiency of spin current conversion to the charge current, was determined by measurements of the angular dependences of spin magnetoresistance of the iridate/manganite interface.
Experimental studies of the electrophysical and magnetic properties of a heterostructure of complex SrIrO3/La0.7Sr0.3MnO3 oxides, where a spin current is observed under ferromagnetic resonance conditions, have been reviewed. thin films of 5d strontium iridate SrIrO3 with a strong spin–orbit coupling and 3d strontium manganite La0.7Sr0.3MnO3 have been grown epitaxially on a (110) NdGaO3 single-crystal substrate by magnetron sputtering at a high substrate temperature of 7000–8000°C in a mixture of argon and oxygen gases at a total pressure of 0.3 mbar. The spin mixing conductance of the interface, which has real (Reg↑↓) and imaginary (Img↑↓) parts, has been determined from the frequency dependences (in the range of 2–20 GHz) of the linewidth and the resonant field of the ferromagnetic resonance of the SrIrO3/La0.7Sr0.3MnO3 heterostructure. The spin Hall angle θSH, which characterizes the efficiency of the conversion of the spin current into an electric current in the presence of the inverse spin Hall effect, has been calculated from the data on the spin magnetoresistance of the SrIrO3/La0.7Sr0.3MnO3 heterostructure. The spin Hall angle θSH of the SrIrO3/La0.7Sr0.3MnO3 heterostructure turns out to be significantly larger (by a factor of almost 40) than that for the Pt/La0.7Sr0.3MnO3 heterostructure.
A technique for obtaining high-quality epitaxial films of iridate (SrIrO3) by high-frequency cathode sputtering on strontium titanate (SrTiO3) and neodymium gallate (NdGaO3) substrates has been developed. The structural features and the influence of mechanical stress relaxation in thin films caused by the difference in the lattice sizes of the film and the substrate have been studied using X-ray diffraction. From the analysis of diffraction data, it was found that lattice parameter deformation is observed in the film. This indicates the emergence of stresses due to the mismatch of the lattice parameters of the film and the substrate, which leads to non-uniform stress relaxation in the film. The electronic transport parameters of thin films and the excitation of spin current in SrIrO3/La0.7Sr0.3MnO3 heterostructures have been investigated.
1
1 October 2023 in Journal of Communications Technology and Electronics
The paper presents the results of experimental determination of the spin Hall angle in a Pt/La0.7Sr0.3MnO3 bilayer metal/ferromagnetic structure inferred from angular dependences of longitudinal and transverse spin magnetoresistance in configuration of the planar Hall effect. The value of the spin Hall angle determined from the longitudinal magnetoresistance is θHx ≈ 0.016, and that from the transverse magnetoresistance is θHy ≈ 0.018, whereas for SrIrO3/La0.7Sr0.3MnO3 heterostructures the ratio of values of the transverse spin Hall angle to the longitudinal one appears to be substantially higher, θHy/θHx ≈ 9, which is apparently caused by a layer with a high spin conductance formed at the SrIrO3/La0.7Sr0.3MnO3 interface.
11 August 2024 in Radioelectronics. Nanosystems. Information Technologies
Разработана методика получения высококачественных эпитаксиальных пленок иридата стронция методом высокочастотного катодного распыления на подложки из титаната стронция и галата ниодима. С помощью рентгеновской дифракции изучены структурные особенности и влияние релаксации механических напряжений в тонких пленках, вызванных различием размеров решетки пленки и подложки. Из анализа дифракционных данных установлено, что в пленке наблюдается деформация параметра решетки. Это свидетельствует о возникновении напряжений, обусловленных несоответствием параметров решетки пленки и подложки, что приводит к неоднородной релаксации напряжений в пленке. Исследованы электронные транспортные параметры тонких пленок и возбуждение спинового тока в гетероструктурах SrIrO3/La0.7Sr0.3MnO3.