The role of the elemental carbon (EC), in synergy with hygroscopic ionic species, was investigated to study the formation of electrical bridging phenomena once the aerosol deliquescence is achieved. Ambient aerosol samples were collected on hydrophobic surfaces in urban and rural sites in Northern Italy; their conductance was measured in an Aerosol Exposure Chamber (AEC) while varying the relative humidity. An electric signal was detected on 64% of the collected samples with conductance values (11.20 ± 7.43 μS) above the failure threshold (1 μS) of printed circuit boards. The ionic content was higher for non-electrically conductive samples (43.7 ± 5.6%) than for electrically conductive ones (37.1 ± 5.6%). Conversely, EC was two times higher for electrically conductive samples (26.4 ± 4.1 μg cm−2; 8.4 ± 1.7%) than for non-electrical ones (12.0 ± 4.1 μg cm−2; 5.2 ± 1.9%) suggesting that the synergy between the ionic and carbonaceous fractions is necessary to promote a bridging phenomenon. Synthetic aerosols (EC only, saline only, mixed saline and EC) were generated in laboratory and their conductance was measured in the AEC to verify the ambient results. Only in case of a contemporary presence of both EC and ionic components the bridging phenomenon occurred in keeping with the theoretical deliquescence values of each salt (R2 = 0.996).
Light-absorbing aerosols (LAA) impact the atmosphere by heating it. Their effect in the Arctic was investigated during two summer Arctic oceanographic campaigns (2018 and 2019) around the Svalbard Archipelago in order to unravel the differences between the Arctic background and the local anthropic settlements. Therefore, the LAA heating rate (HR) was experimentally determined. Both the chemical composition and high-resolution measurements highlighted substantial differences between the Arctic Ocean background (average eBC concentration of 11.7 ± 0.1 ng/m3) and the human settlements, among which the most impacting appeared to be Tromsø and Isfjorden (mean eBC of 99.4 ± 3.1 ng/m3). Consequently, the HR in Isfjorden (8.2 × 10−3 ± 0.3 × 10−3 K/day) was one order of magnitude higher than in the pristine background conditions (0.8 × 10−3 ± 0.9 × 10−5 K/day). Therefore, we conclude that the direct climate impact of local LAA sources on the Arctic atmosphere is not negligible and may rise in the future due to ice retreat and enhanced marine traffic.
The reliability of the national power grid is a key issue in modern society. Atmospheric aerosols are the main cause of the reduction in the performance of insulators and the increase in the possibility of flashovers, resulting in power line failures. Under high ambient humidity, the water-soluble compounds of atmospheric aerosols collected on the insulators’ surface can dissociate in ions and form a conductive layer, which may lead to flashover events. With a view to investigating the processes that drive these phenomena, the chemical composition of aerosol deposits on insulators in Italy was determined by ion chromatography analysis and thermos-optical and X-ray techniques. In addition, a synthetic aerosol with the same analyzed chemical composition was generated in a laboratory and deposited on PTFE filters and glass specimens allowing us to determine the deliquescence and crystallization relative humidity and the conductive effect in an aerosol exposure chamber. The results evidenced the presence of a hazardous inorganic ion layer, which generates a sharp phase transition of the aerosol deposit as a function of the ambient relative humidity; this layer poses a dangerous threat to the reliability of the power grid, increasing the probability of flashover events where the conductive layer facilitates the flow of electrical current across the insulator surface, potentially causing power outages or damage to the power lines.
The hygroscopic behavior of atmospheric aerosols is controlled by their chemical composition, which determines phase transitions, water uptake and physical state. Aerosol hydration influences particle size, mass, optical and chemical properties, making it a key process in atmospheric science. This study evaluates the performance of ISORROPIA 2.1, a thermodynamic equilibrium model, in predicting aerosol water uptake across a wide range of aerosol types, including indoor and outdoor (urban, extra-urban and marine) aerosols and deposits on electrical insulators. Inorganic composition was determined by ion chromatography, while deliquescence behavior was experimentally characterized using an Aerosol Exposure Chamber, providing a comprehensive dataset for model validation. ISORROPIA 2.1 accurately reproduces deliquescence relative humidity (DRH) and hygroscopic growth in sulfate–nitrate–ammonium dominated systems, with mean deviations of 4.3 ± 2.6 % RH for the onset of deliquescence (DRHs) and 4.4 ± 3.2 % RH for completion (DRHe). In contrast, ammonium-poor mixtures enriched in alkali and alkaline-earth ions (K+, Mg2+, Ca2+, Na+), including marine aerosol and insulator deposits, show non-physical humidification behavior characterized by discontinuous liquid–solid transitions. These anomalies arise from routine-selection instabilities in dust-rich regimes. Targeted code refinements improved model stability and water-uptake predictions, extending the applicability of ISORROPIA 2.1 to sulfate-poor, sodium- and crustal-rich systems. Overall, this work provides an experimental benchmark for aerosol thermodynamics, identifies the compositional limits of ISORROPIA 2.1 and broadens its applicability to complex inorganic aerosol mixtures.
The hygroscopic behavior of atmospheric aerosols is controlled by their chemical composition, which determines phase transitions, water uptake and physical state. Aerosol hydration influences particle size, mass, optical and chemical properties, making it a key process in atmospheric science. This study evaluates the performance of ISORROPIA 2.1, a thermodynamic equilibrium model, in predicting aerosol water uptake across a wide range of aerosol types, including indoor and outdoor (urban, extra-urban and marine) aerosols and deposits on electrical insulators. Inorganic composition was determined by ion chromatography, while deliquescence behavior was experimentally characterized using an Aerosol Exposure Chamber, providing a comprehensive dataset for model validation. ISORROPIA 2.1 accurately reproduces deliquescence relative humidity (DRH) and hygroscopic growth in sulfate–nitrate–ammonium dominated systems, with mean deviations of 4.3 ± 2.6 % RH for the onset of deliquescence (DRHs) and 4.4 ± 3.2 % RH for completion (DRHe). In contrast, ammonium-poor mixtures enriched in alkali and alkaline-earth ions (K+, Mg2+, Ca2+, Na+), including marine aerosol and insulator deposits, show non-physical humidification behavior characterized by discontinuous liquid–solid transitions. These anomalies arise from routine-selection instabilities in dust-rich regimes. Targeted code refinements improved model stability and water-uptake predictions, extending the applicability of ISORROPIA 2.1 to sulfate-poor, sodium- and crustal-rich systems. Overall, this work provides an experimental benchmark for aerosol thermodynamics, identifies the compositional limits of ISORROPIA 2.1 and broadens its applicability to complex inorganic aerosol mixtures.