The present study examines the effect of heat transfer on electrically conducting MHD micropolar fluid flow along a semi-infinite horizontal plate with radiation and heat source. The uniform magnetic field has applied along the principal flow direction. The obtained governing equations have been converted into a set of dimensionless differential equations and then numerically solved by using a well-known Runge-Kutta method with shooting technique. The velocity, microrotation, and temperature distribution are presented for various physical parameters. The numerical values of skin friction and Nusselt numbers at the plates are shown in tabular form, and the obtained results are compared with the results of a previous study. It has been found that the magnetic parameter increases the velocity profile whereas the boundary layer thickness reduces due to the inclusion of coupling parameter and inertia effect. The presence/absence of magnetic parameter and coupling parameter enable to enhance the angular velocity profile while it is worth to note that the backflow has generated in the vicinity of the plate.
23 March 2018 in Neural Computing and Applications
In multiphase particulate systems, the turbulence of the continuous phase (gas or liquid) is modulated due to interactions between the continuous phase and the suspended particles. Such phenomena are non-trivial in the essence that addition of a dispersed phase to a turbulent flow complicates the existing flow patterns depending on the physical properties of the particles leading to either augmentation or attenuation of continuous phase turbulence. In the present study, this aspect has been comprehensively analysed based on the available experimental data obtained from the well-studied turbulent flow systems such as channel and pipes, free jets and grids. Relevant non-dimensional parameters such as particle diameter to integral length scale ratio, Stokes number, particle volume fraction, particle momentum number, and particle Reynolds number have been utilised to characterise the reported turbulence modulation behavior. Some limitations of these commonly used dimensionless parameters to characterise turbulence modulation are discussed, and possible improvements are suggested.
An oral killed cholera vaccine containing 1 x 10(11) cells of Vibrio cholerae O1 (heat- or formalin-killed) representing the Ogawa and Inaba biotypes and containing 1 mg of B-subunit of cholera toxin (CTB) produced by recombinant DNA technology (the WC/rCTB vaccine) was subjected to temperatures of 4 C, 30 C or 42 C for up to 6 months time. Lipopolysaccharide antigen (LPS) and CTB content of the vaccine samples determined at various times remained unchanged during the study except for the CTB component which decreased by about 50% after 6 months of storage at 42 C. Immunogenicity determined by immunization of rabbits with the vaccine in Freund's complete adjuvant and measuring anti-LPS and anti-CTB antibody titers in the serum by an ELISA was also found to be unaltered. Lyophilization of the vaccine and storage at room temperature for 7 days also did not have any adverse effect on antigen content or immunogenicity as tested above. There was up to one log reduction in serum antibody titers after immunization without using any adjuvant or using Freund's incomplete adjuvant, and up to two logs following oral immunization. Immunization by oral feeding of the vaccine followed by RITARD challenge with a virulent V. cholerae O1 strain showed evidence of protection against severe or lethal diarrhea. The results suggest that the vaccine retains its antigen content and ability to induce antibodies unchanged when maintained at elevated temperatures for relatively long periods of time.