This article presents an experimental testing campaign on large-scale concrete specimens with cross-sectional areas of up to 1 m2 and a specimen length of 3 m. The primary goal of the testing campaign was to study the shrinkage behaviour of large-scale specimens exposed to real environmental conditions. Large-scale prismatic concrete specimens were equipped with vibrating wire strain gauges to monitor the strain evolution inside the specimens. To analyse the shrinkage behaviour of the specimens, the thermal strain had to be deducted from the measured strain. To study the influence of seasonal environmental conditions, different specimen production dates (in summer and winter) were examined. The measured shrinkage strains of the large-scale specimens are compared with the results of shrinkage models developed by two engineering entities (fib (Fédération Internationale du Béton) and RILEM (International Union of Laboratories and Experts in Construction, Materials, Systems and Structures)). The comparison shows a poor agreement of the measurements with the models, even though the results from the model for small specimens tested in the laboratory under constant environmental condition agree well with the experimental results. This leads to the conclusion that the poor agreement between the measurements and the shrinkage models must be due to the seasonally changing environmental conditions. The comparison of the results from specimens with different production dates shows that different shrinkage behaviour occurs, especially in the first year of measurements.
In this article, a testing campaign on large‐scale concrete specimens to study the influence of environmental conditions on their creep behavior for different member sizes is presented. This testing campaign is unique due to its specimen dimensions (cross‐sectional areas of up to 1 m2) and the continuous deformation measurements for over 6 years. To quantify the influence of the environmental conditions on the creep behavior, two types of test specimens were produced, consisting of the same concrete mixture but having different production dates (summer of 2017 and winter of 2018). The large‐scale specimens were stored outside and therefore exposed to real environmental conditions. The measurement data collected over more than 6 years show that the environmental conditions during the first year have a tremendous impact on the creep behavior of the large‐scale specimens. Furthermore, the experimentally determined creep compliance of the specimens produced in winter exceeded that of the specimens produced in summer.