This article presents an experimental testing campaign on large-scale concrete specimens with cross-sectional areas of up to 1 m2 and a specimen length of 3 m. The primary goal of the testing campaign was to study the shrinkage behaviour of large-scale specimens exposed to real environmental conditions. Large-scale prismatic concrete specimens were equipped with vibrating wire strain gauges to monitor the strain evolution inside the specimens. To analyse the shrinkage behaviour of the specimens, the thermal strain had to be deducted from the measured strain. To study the influence of seasonal environmental conditions, different specimen production dates (in summer and winter) were examined. The measured shrinkage strains of the large-scale specimens are compared with the results of shrinkage models developed by two engineering entities (fib (Fédération Internationale du Béton) and RILEM (International Union of Laboratories and Experts in Construction, Materials, Systems and Structures)). The comparison shows a poor agreement of the measurements with the models, even though the results from the model for small specimens tested in the laboratory under constant environmental condition agree well with the experimental results. This leads to the conclusion that the poor agreement between the measurements and the shrinkage models must be due to the seasonally changing environmental conditions. The comparison of the results from specimens with different production dates shows that different shrinkage behaviour occurs, especially in the first year of measurements.
Sustainable concretes, also termed eco-concretes or green concretes, produced with a significantly reduced cement content provide a promising alternative for improving concrete sustainability without using supplementary cementitious materials, such as fly ash or slag. However, the production of such eco-concretes is a challenge in view of concrete technology and concrete properties. In particular, new design concepts as well as new admixtures have to be developed and applied to produce concretes with a cement clinker content of approx. 100 kg/m3 while keeping the concrete performance on a level similar to ordinary structural concrete of today. To evaluate the sustainability of these new types of concretes not only the very low ecological impact due to the composition may be regarded, but in addition also their technical performance, i.e. their mechanical, physical and chemical properties have to be taken into consideration. This contribution firstly gives an overview on sustainable approaches for concrete structures, further introduces the Building Material Sustainability Potential as an index, which is applied in combination with the service life prediction for cement-reduced concretes using full probabilistic methods. The composition of these particular structural concretes is discussed and related test results for their performance are presented. The contribution closes with an introduction to graded concrete structures as an innovative approach for the improvement of concrete sustainability on a structural level and presents testing results for mechanical and durability properties of graded bending beams. The paper at hand extends the information given in [1] by looking more closely at the performance of graded concrete structures and here in particular by considering concretes produced from intermixing two concrete types (i.e. eco-concrete and UHPC) in the fresh state.