Spinel LiMn₂O₄ (LMO) is a state-of-the-art cathode material for Li-ion batteries. However, the operating voltage and battery life of spinel LMO needs to be improved for application in various modern technologies. Modifying the composition of the spinel LMO material alters its electronic structure, thereby increasing its operating voltage. Additionally, modifying the microstructure of the spinel LMO by controlling the size and distribution of the particles can improve its electrochemical properties. In this study, we elucidate the sol-gel synthesis mechanisms of two common types of sol-gels (modified and unmodified metal complexes)—chelate gel and organic polymeric gel—and investigate their structural and morphological properties and electrochemical performances. This study highlights that uniform distribution of cations during sol-gel formation is important for the growth of LMO crystals. Furthermore, a homogeneous multicomponent sol-gel, necessary to ensure that no conflicting morphologies and structures would degrade the electrochemical performances, can be obtained when the sol-gel has a polymer-like structure and uniformly bound ions; this can be achieved by using additional multifunctional reagents, namely cross-linkers.

In earlier studies, much research has focused on increasing the efficiency of heat exchanger fields. Therefore, in this study, graphene nanofluid was fabricated for use as a heat transfer medium for a heat exchanger. Graphene has excellent electrical conductivity, mechanical properties, and heat transfer properties. It is expected that the heat transfer efficiency will be improved by fabricating the nanofluid. However, graphene is prone to sedimentation, because of its cohesion due to van der Waals binding force. In this experiment, a nanofluid was fabricated with enhanced dispersibility by surfactant and the ball-milling process. The zeta potential, absorbance, and thermal conductivity of the nanofluid were measured. As a result, when using the ratio of 2:1 (graphene:sodium dodecyl sulfate (SDS)), a higher thermal conductivity was obtained than in other conditions.

As electronic devices and mainboards become smaller, the need for thermal conductive materials having excellent internal heat dissipation is increasing. In this study, nano thermal grease was prepared by mixing in copper nanopowder, which is used as a heat transfer medium in thermal grease, which is a kind of thermal conductive material, with silicon oil. In addition, copper powder was mixed with graphene and alumina, respectively, and the thermal conductivity performance was compared. As a result, the thermal conductivity improved by 4.5 W/m·k over the silicon base, and the upward trend of thermal conductivity increased steadily up to 15 vol. %, and the increasing trend decreased after 20 vol. %. In addition, the increased rate of thermal conductivity from 0 to 5 vol. % and 10 to 15 vol. % was the largest.

In order to activate the high precision and multi-functional machine tool, adequate technical level of the high-precision products is required. The hydrostatic bearings is used as a method for producing the high-precision products. The hydrostatic bearing has a relatively small run-out compared to its shape error by fluid film effect in hydrostatic state similar to pneumatic bearing and has high stiffness, load capacity and damping characteristics. In this study, we conducted a study on the thermal deformation of the grinding machine that has a great influence on the machining accuracy of the product. The temperature of the front bearing is 10°C or higher than the temperature of the rear bearing. Thermal deformation of the spindle was found to be dependent on the temperature of the hydrostatic bearing and could identify the overall thermal characteristics of the grinding machine.