During the consolidation period of vacuum preloading drainage of dredged mud slurry, the clogging behaviors of the filter drainage structural layers and the core boards of prefabricated vertical drains (PVD) determine the drainage capacities of PVD. However, currently, there is a lack of comprehensive research on the evaluation criteria for these two clogging behaviors. Therefore, based on typical dredged mud slurry, typical geomembranes, and raw material core boards with different bending forms, relevant macro and micro-scale experimental studies have been carried out in this study. The research results show that (1) with the application of the gradient ratio test method, the clogging behaviors of filter membranes of PVD under graded vacuum preloading can be effectively simulated. Also, in the design of graded vacuum preloading, characteristics of equivalent pore sizes and pore structures should be emphasized to investigate the suitability of filtration and drainage performance of PVD filter membranes. (2) The compressive yield strength of core board grooves is a key factor influencing the reduction rate of flow capacity. The reduction rate of flow capacity and well resistance increment can be used as comprehensive indicators reflecting the clogging behaviors of core boards, while the bending angles and bending rates of core boards can be used as specific technical indicators. (3) The proposed clogging evaluation criteria for PVD are as follows: a filter membrane gradient ratio (GR) > 4.0, a core board bending rate >60% and a core board bending angle < 45°, or a reduction rate of flow capacity of bending drainage board > 90% or well-resistance increment > 9. Also, these criteria can be incorporated into the control indicators for drainage performance of PVD used in such types of foundations.

Energy piles are highly favored for their excellent, low energy consumption in providing heating for public residences. The temperature field changes the activity of the diffuse double electric layer (DEL) on the particle surface, thereby altering the distribution of the stress field in the soil and ultimately affecting the mechanical properties of the interface between the energy pile and the soil. Therefore, studying the influence of water content on the mechanical behavior of the soil–structure interface in the temperature field is crucial for energy pile safety. This study used a modified temperature-controlled direct shear apparatus to obtain the influence of water content and temperature on the shear behavior of the soil–structure interface. Then, the test results were analyzed and discussed. Finally, three results were obtained: (1) The water content of bentonite (w_bent) had a significant impact on the shear stress–shear displacement curve of the soil–structure interface; when the w_bent was less than the w_p of the bentonite, the τ-l curve exhibited a softening response, then displayed a hardening response. (2) The shear strength of the soil–structure interface gradually decreased with the increase of w_bent. (3) The shear strength of the soil–structure interface increased with increasing temperature under various w_bent and vertical loads.

Since the exploration of the characteristics of dredged mud slurry during batch settlement and low-pressure consolidation (less than 100 kPa) is still insufficient, the determination of the optimal time to start the vacuum preloading method (VPM) on dredged-fill foundations is still empirically oriented (due to a lack of enough scientific basis). To further explore the characteristics of dredged mud slurry during batch settlement and low-pressure consolidation, samples from typical dredged-fill land projects were obtained and used to conduct batch sedimentation model experiments and low-pressure (less than 100 kPa) consolidation tests. The results of experiments and analyses showed the following: (1) the clay (d < 0.005 mm) content is a main factor affecting the batch settlement and consolidation characteristics of dredged mud slurry, which is not conducive to the consolidation effect of dredged-fill foundations. (2) For dredged mud slurry whose clay content is within 40% to 60%, the cumulative change rate of the average porosity ratio of 60% to 75% is suitable for evaluating the steady state of its batch sedimentation process, i.e., the optimal starting time of VPM. Finally, based on the experimental analyses, a settlement prediction method that considers both the batch sedimentation and the low-pressure consolidation processes was developed and validated.