Partial pair distribution functions, XRD patterns, segmental dynamics, elastic constants and glass temperature in EPON862/DETDA epoxy predicted through molecular dynamics.

A combined computational and experimental study of 3D-printed scaffolds made from hybrid nanocomposite materials for potential applications in bone tissue engineering is presented. Polycaprolactone (PCL) and polylactic acid (PLA), enhanced with chitosan (CS) and multiwalled carbon nanotubes (MWCNTs), were investigated in respect of their mechanical characteristics and responses in fluidic environments. A novel scaffold geometry was designed, considering the requirements of cellular proliferation and mechanical properties. Specimens with the same dimensions and porosity of 45% were studied to fully describe and understand the yielding behavior. Mechanical testing indicated higher apparent moduli in the PLA-based scaffolds, while compressive strength decreased with CS/MWCNTs reinforcement due to nanoscale challenges in 3D printing. Mechanical modeling revealed lower stresses in the PLA scaffolds, attributed to the molecular mass of the filler. Despite modeling challenges, adjustments improved simulation accuracy, aligning well with experimental values. Material and reinforcement choices significantly influenced responses to mechanical loads, emphasizing optimal structural robustness. Computational fluid dynamics emphasized the significance of scaffold permeability and wall shear stress in influencing bone tissue growth. For an inlet velocity of 0.1 mm/s, the permeability value was estimated at 4.41 × 10⁻⁹ m², which is in the acceptable range close to human natural bone permeability. The average wall shear stress (WSS) value that indicates the mechanical stimuli produced by cells was calculated to be 2.48 mPa, which is within the range of the reported literature values for promoting a higher proliferation rate and improving osteogenic differentiation. Overall, a holistic approach was utilized to achieve a delicate balance between structural robustness and optimal fluidic conditions, in order to enhance the overall performance of scaffolds in tissue engineering applications.

Interfacial shear strength (IFSS) is a key property in the design of composites and nanocomposites. Many simulation studies quantify the interfacial characteristics of sandwichlike specimens in terms of the IFSS and pullout force; a common feature of these studies is that they employ finite model systems and are therefore subject to strong finite size effects. We propose an alternative approach which is applicable to both aperiodic and periodic computational specimens. The interfaces are subjected to multiple shear deformation simulations over a wide range of temperatures ($T$) and shear stresses (${\sigma }_{zx}$). From these simulations we collect the failure times ($t_{\mathrm{f}}$); by analyzing them in the framework of an extended Boltzmann-Arrhenius-Zhurkov kinetic equation we derive the IFSS, the limiting stress for barrierless transitions, the activation energy, the activation volume for failure, the sliding velocities, and a local elastic shear modulus for the interface. We test our methodology on epoxy diglycidyl ether bisphenol F–diethyl toluene diamine interfaces in contact with (i) pristine graphene, (ii) graphene with single-atom vacancies, and (iii) graphene with hydroxyl-ΟΗ groups. Differences in the mechanism of interfacial failure among these three systems are discussed.

In this research work, we provide a detailed investigation of the structural and viscoelastic properties of crosslinked styrene butadiene rubber (SBR) networks that are studied using atomistic molecular dynamics simulations.