Electrical breakdown is an important physical phenomenon in power equipment and electronic devices. Recently, the mechanism of AC and DC breakdown has been preliminarily revealed as electrode–dielectric interface breakdown and bulk breakdown, respectively, based on space charge dynamics through numerical calculations. However, the AC breakdown mechanism still lacks enough direct experimental support, which restricts further understanding and the design and development of electrical structures. Here, in this study, LDPE films with various thicknesses ranging from 33 μm to 230 μm were surface modified with ozone for different durations to experimentally investigate DC and AC breakdown mechanism. The results indicate that carbonyl groups (C=O) were introduced onto the film surface, forming shallow surface traps and leading to a decreased average trap depth and an increased trap density. Such a surface oxidation modulated trap distribution led to enhanced space charge injection and bulk electrical field distortion, which decreased DC breakdown strength as the oxidation duration went longer, in all film thicknesses. However, such decreases in breakdown strength occurred only in films below 55 μm under AC stresses, as the enhanced electrical field distortion at the electrode–dielectric interface was more obvious and dominating in thin films. These experimental results further confirm the proposed electrode–dielectric interface breakdown of dielectric films and provide new understandings of space charge modulated electrical breakdown, which fulfills dielectric breakdown theory and benefits the miniaturization of power equipment and electronic devices.
With the increasing demand for safety and sustainable development in the power industry, the research on synthetic esters as a new type of insulating oil is becoming more and more important. This article takes pentaerythritol ester as the research object, simulates its fault conditions under partial discharge (low-energy discharge) and spark discharge (high-energy discharge), studies the dielectric and gas production characteristics, and explores the applicability of the existing fault diagnosis methods for synthetic esters. The results show that during partial discharge, the dielectric constant and loss of the synthetic ester increase, and the resistivity decreases. With the increase of discharge time, the relative percentage of CO continuously decreases, while that of C2H6 and C2H4 continuously increases. Since the C2H4 content of the synthetic ester is significantly higher than that of the mineral oil, the commonly used diagnostic methods are not suitable for the partial discharge fault diagnosis of the synthetic ester. In spark discharge, the gap distance has little impact on the starting voltage but a great impact on the breakdown time, and the dielectric performance deteriorates seriously. C2H2 is the characteristic gas of the synthetic ester spark discharge, and a large amount is produced, but with the increase of the gap distance, its relative percentage continuously decreases. For the spark discharge fault diagnosis of the synthetic ester, the improved three-ratio method and DUVAL triangle method have certain applicability. Comparing different discharge energies, the increase of the discharge energy aggravates the deterioration of the synthetic ester. Under high-energy discharge, the dielectric constant increases significantly, the hydrocarbons increase rapidly, and the C2H2 content increases sharply. Finally, the Duval triangle was modified according to the gas generation characteristics. This research can provide data support for the application and fault diagnosis of synthetic esters in power transformers.