Liang Yang

Dr. Liang Yang


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 May 2022 in Journal of Physics D: Applied Physics
Verified
Journal Article
Open access
YXYongfeng Xu
Yongfeng Xu
LYLiang Yang
Liang Yang
DZDongjian Zhou
Dongjian Zhou
BLBenkang Liu
Benkang Liu
QLQingwei Li
Qingwei Li
YJYuqi Jin
Yuqi Jin
In this paper, impulse measurement, spectral diagnostics, temporal evolution images and target ablation are employed to investigate the dynamic behaviors and parameters of Nd:YAG nanosecond laser-induced aluminum plasma at different pressures and laser fluences. The impulses and coupling coefficients generated by laser ablation increase firstly and then reduce with the decrease in pressure for the laser fluences of 17.22 J cm−2 and 20.94 J cm−2, but they only drop at 0.5 Torr for a laser fluence of 6.19 J cm−2. The fast exposure images captured by the high-speed camera and ICCD show that the plasma plumes present the separation at atmospheric pressure and expansion near vacuum, but last longer time at pressures of 150 Torr and 22 Torr. The duration and dynamic property of plasma are responsible for the impulse, as well as are mainly dependent on the characteristics of plasma parameters. Therefore, the electron density and electron temperature are obtained by Stark broadening method and Boltzmann plot, respectively. The change in the electron density is proportional to pressure and laser fluence. The variation trend of the crater depth and ablative mass with pressure is opposite to that of the electron density, which is ascribed to the plasma shielding effect caused by the inverse bremsstrahlung absorption mechanism. Besides, the electron temperature varies inversely with pressure in the detection range due to various recombination processes. This study provides an insight for clarifying the energy conversion mechanism and improving the laser propulsion performance.

8 August 2024 in Journal of Physics D: Applied Physics
Verified
Journal Article
Open access
YXYongfeng Xu
Yongfeng Xu
LYLiang Yang
Liang Yang
JLJiaqi Li
Jiaqi Li
DZDongjian Zhou
Dongjian Zhou
QLQingwei Li
Qingwei Li
YJYuqi Jin
Yuqi Jin
Propulsion performance produced by laser ablation of polymer made of acrylonitrile butadiene styrene is experimentally investigated using the first, second, and third harmonics of a Nd: YAG laser. A ballistic pendulum is employed to assess the impulse and coupling coefficient for laser propulsion application. Fast photography, target ablation, and optical emission spectroscopy are proposed to analyze the energy coupling characteristic. The impulse and coupling coefficient under different pressures are demonstrated to depend on the target ablation and plasma properties which are relevant to laser wavelength. As the laser wavelength decreases, the crater depth and ablation mass are enhanced. Meanwhile, the plasma plume separates at atmospheric pressure and its length extends continuously in the low-pressure range. As a result, plasma including more ejected particles with higher velocity contributes to obtaining excellent impulse and coupling coefficient. In addition, the decreased electron density and temperature indicate higher collision frequency and photoionization dominate rather than inverse bremsstrahlung absorption at shorter laser wavelengths. This work provides a better understanding of the energy conversion mechanism and a reference for improving propulsion performance.

6 March 2023 in Journal of Physics D: Applied Physics
Verified
Journal Article
Open access
YXYongfeng Xu
Yongfeng Xu
LYLiang Yang
Liang Yang
DZDongjian Zhou
Dongjian Zhou
QLQingwei Li
Qingwei Li
WSWenbo Shi
Wenbo Shi
YJYuqi Jin
Yuqi Jin
In this study, the influence of laser energy and pressure on propulsion performance of zinc and acrylonitrile butadiene styrene (ABS) is investigated by impulse measurement, fast exposure images, spectral diagnostics and target ablation. A Q-switched Nd:YAG laser with the wavelength of 1064 nm and pulse width of 6 ns is employed. The impulse and coupling coefficient generated by laser ablation ABS are greater than that of Zn, and they exhibit a similar variation trend with pressure. However, at higher pressure levels, the change in impulse versus laser energy is not completely coincident between Zn and ABS samples. The target property plays a significant role in the generation and propagation of plume related to the plasma parameters such as electron density and temperature. The temporal evolution images indicate that the plasma plume of laser-induced Zn presents a faster decay in comparison with that of ABS, which is ascribed to the fact that the gas temperature of ABS is higher than the electron temperature of Zn plasma in the local thermodynamical equilibrium. Also, the electron density is lower for Zn due to the rapid heat diffusion and higher ablation threshold of metal. It is found that the surface absorption is dominant for metal because the ablated crater of Zn performs larger diameter and shallower depth. On the contrary, the shrinkage in diameter but enhancement in depth of crater is observed from ABS surface, and the ablation mass is larger, suggesting the obvious volume absorption for polymer. The results reveal that the target property can engender an important effect on the energy conversion between laser, target and plasma.

1 September 2023 in Physics of Plasmas
Verified
Journal Article
Open access
PDF file
YXYongfeng Xu
Yongfeng Xu
LYLiang Yang
Liang Yang
DZDongjian Zhou
Dongjian Zhou
QLQingwei Li
Qingwei Li
WSWenbo Shi
Wenbo Shi
YJYuqi Jin
Yuqi Jin
The dependence of propulsion performance generated by laser ablation of polyvinyl chloride on laser energy and pressure is investigated using Q-switched Nd: YAG laser with the wavelength of 1064 nm. When the pressure is decreased, the impulse and coupling coefficient rise first and then decline. Such a trend is also reflected in the variation of coupling coefficient with laser energy in the whole pressure range. However, the change in impulse with laser energy at atmospheric pressure is not completely consistent with that at low pressure levels. The dynamic behavior and duration of plasma plume are considered to be the factors for the difference in propulsion performance. By capturing the fast exposure images of plume, the separation at atmospheric pressure and severe expansion accompanied by rapid quenching in near vacuum are observed. Moreover, the plasma plume lasts longer time at high pressures. It is ascribed to the higher electron temperature, which promotes background gas to excite and ionize. Since the electron density increases with the improvement of laser energy and pressure, the absorption of electrons to laser energy becomes stronger through the inverse bremsstrahlung mechanism. Accordingly, the shielding effect of plasma is enhanced, causing the weak laser-target interaction. The result is that the crater depth and ablative mass increase with decreasing pressure. This work is important for understanding the energy conversion mechanism and optimizing the laser propulsion performance.

8 December 2022 in Plasma Physics and Controlled Fusion
Verified
Journal Article
Closed access
CZChongxiao Zhao
Chongxiao Zhao
YCYiYi Chen
YiYi Chen
JSJian Song
Jian Song
XMXianxiu Mei
Xianxiu Mei
KPKun Qi Pan
Kun Qi Pan
DWDezhen Wang
Dezhen Wang
Plasma wall interaction inevitably occurs during the operation of tokamaks. The coaxial gun device has low operation cost and the parameters of plasma produced by the gun are close to those of type I edge localized mode (ELM); therefore, the coaxial gun is suitable in simulation experiments as a heat flux source of transient events such as type I ELM under the condition of H-mode in the International Thermonuclear Experimental Reactor. In this paper, the plasma generated by the discharge of a tapered coaxial accelerator thermal shock on a tungsten target is used to simulate the damage effect of the divertor. The plasma parameters are measured in the experiment. The velocity of the plasma is 41.7 km s−1, and the kinetic energy of a single hydrogen ion is 9.2 eV. The energy density at the center of the plasma can reach 1.5 MJ m−2, and the density can reach about 2.78 × 1015 cm−3. The reflection of plasma in the process of exposure at different angles is observed. It is observed that droplets of millimeter size splash from the target. Traces of liquid flow are observed on the surface of the target, which shows that there is a melting process on the surface of the target. The mass loss of the target is of the order of milligrams after 20 pulses. The ablation and residual stress of the target surface both decrease with a decrease in the angle. This is because the accumulated energy per unit area of the target surface decreases with a decrease in the angle. The results of the simulation experiment help us to understand the working state around the divertor target in tokamak devices.

28 October 2025 in International Journal of Hydrogen Energy
Verified
Journal Article
Open access
JLJiaqi Li
Jiaqi Li
LYLiang Yang
Liang Yang
YXYongfeng Xu
Yongfeng Xu
QLQingwei Li
Qingwei Li
WSWenbo Shi
Wenbo Shi
YJYuqi Jin
Yuqi Jin