The menisci increase the contact area of load bearing in the knee and thus disperse the mechanical stress via their circumferential tensile fibers. Traumatic meniscus injuries cause mechanical symptoms in the knee, and are more prevalent amongst younger, more active patients, compared to degenerative tears amongst the elderly population. Traumatic meniscus tears typically result from the load-and-shear mechanism in the knee joint. The treatment depends on the size, location, and pattern of the tear. For non-repairable tears, partial or total meniscal resection decreases its tensile stress and increases joint contact stress, thus potentiating the risk of arthritis. A longitudinal vertical tear pattern at the peripheral third red-red zone leads to higher healing potential after repair. The postoperative rehabilitation protocols after repair range from immediate weight-bearing with no range of motion restrictions to non-weight bearing and delayed mobilization for weeks. Pediatric and adolescent patients may require special considerations due to their activity levels, or distinct pathologies such as a discoid meniscus. Further biomechanical and biologic evidence is needed to guide surgical management, postoperative rehabilitation protocols, and future technology applications for traumatic meniscus injuries.
3 November 2022 in JSES Reviews, Reports, and Techniques
Glenoid bone loss presents a challenging dilemma, particularly in the setting of failed arthroplasty requiring conversion to a reverse total shoulder arthroplasty (rTSA). The aim of our systematic review was to examine the success and failure of biologic glenoid bone grafting to address vault deficiencies in the setting of shoulder arthroplasty conversion to rTSA. Twelve articles were included and a complete PUBMED search. Inclusion criteria included glenoid bone grafting for conversion of failed arthroplasty and a minimum of 12 months follow-up. Exclusion criteria included grafting for primary rTSA, and re-revision for infection or humeral loosening. Failures were defined as failure of the graft to radiographically incorporate, symptomatic base plate loosening, and need for further surgical re-revision. Two hundred patients were identified across the 12 articles. Eighteen percent (36/200) of all cases demonstrated failure to radiographically incorporate. Thirteen percent (25/200) of all grafting cases required re-revision due to symptomatic failure (pain or functional deterioration). Femoral shaft demonstrated the highest failure rate at 88% (7/8). Grafting for glenoid bone loss in the setting of conversion to rTSA has an 82% rate of success across autograft and allograft utilization. Further studies are needed to better define the success of autografting versus allografting in the setting of shoulder arthroplasty conversion to rTSA with glenoid bone loss.
1 January 2024 in Video Journal of Sports Medicine
Background: Anterior cruciate ligament (ACL) repairs, once widely abandoned due to historically high failure rates, have recently regained interest with the development of the bridge-enhanced ACL repair (BEAR) implant, a novel arthroscopic technique that uses a resorbable protein-based implant combined with autologous blood to primarily repair a midsubstance ACL tear. This technical note presents a step-by-step surgical method for performing an isolated midsubstance ACL repair using the BEAR implant. Indications: The BEAR implant is indicated for skeletally mature patients at least 14 years of age with a complete rupture of the ACL, confirmed by magnetic resonance imaging. The complete ACL tear must have an attached stump to the tibia. Technique Description: A diagnostic arthroscopy is used to confirm complete rupture of the ACL and presence of residual tibial stump. A self-retrieving suture passage device is used to whipstitch a total of 6 passes with #2 Vicryl suture from distal to proximal through the residual stump. A notchplasty followed by femoral and tibial tunnels is created in a standard fashion. An Endobutton, soaked in a bacitracin solution, is then loaded with the sutures that were previously passed through the residual ACL stump and then through the femoral tunnel and cinched down to bone. The 4 suture ends that are coming from the Endobutton are then passed through the BEAR implant with the use of a Keith needle and shuttled through the tibial tunnel. The BEAR implant is hydrated with 15 cc of the patient's blood and is shuttled through the anteromedial portal with the knee in full extension. The 4 tibial sutures passed through the graft and tibial tunnel are passed, and tensioned to the proximal tibial with a second Endobutton. Standard closure and dressings are applied. Results: This new surgical implant and technique have shown noninferiority to ACL autograft reconstruction with respect to the International Knee Documentation Committee and anteroposterior laxity, with improved hamstring strength and decreased incidence of contralateral ACL tears at 2 years postoperative. Discussion/Conclusion: While initial data remain promising, future long-term designed studies are needed to determine the clinical efficacy of the BEAR technique, particularly comparing itself with bone-patellar tendon-bone autograft ACL reconstruction. Patient Consent Disclosure Statement: The author(s) attests that consent has been obtained from any patient(s) appearing in this publication. If the individual may be identifiable, the author(s) has included a statement of release or other written form of approval from the patient(s) with this submission for publication.
Femoral perforation during total hip arthroplasty is a rare complication. Most of the existing literature regarding the complication involves acutely recognized perforations. We report a case of femoral component revision for a symptomatic femoral perforation 12 years after a primary cementless total hip arthroplasty. The revision allowed for intramedullary component positioning, restoration of femoral length and offset, pain relief, and functional improvement. While management of this complication is debatable, we recommend revision in order to avoid future complications and optimize patient outcomes.