With the huge generation of municipal solid waste (MSW), proper management and disposal of MSW is a worldwide challenge for sustainable development of cities and high quality of citizens life. Although different disposal ways are available, incineration is a leading harmless approach to effectively recover energy among the applied technologies. The purpose of the present review paper is to detail the discussion of evolution of waste to energy incineration and specifically to highlight the currently used and advanced incineration technologies, including combined incineration with other energy, for instance, hydrogen production, coal and solar energy. In addition, the environmental performance is discussed, including the zero waste emission, leachate and fly ash treatment, climate change contribution and public behaviour. Finally, challenges, opportunities and business model are addressed. Trends and perspectives on policies and techno-economic aspects are also discussed in this review. Different simulation tools, which can be used for the thermodynamic assessment of incineration plants, are debated; life-cycle inventory emissions and most critical environmental impacts of such plants are evaluated by life-cycle analysis. This review shows that waste incineration with energy yield is advantageous to handle waste problems and it affects climate change positively.

The concentration ratio of the parabolic dish solar collector (PDSC) is considered to be one of the highest among the concentrated solar power technologies (CSPs); therefore, such system is capable of generating more heat rate. The present paper focuses on the integration of the PDSC with the combined cycle (gas cycle as the toping cycle and steam cycle as the bottoming cycle) along with the utilization of waste heat from the power cycle to drive the single effect lithium bromide/water absorption cycle. Molten salt is used as a heat transfer fluid in the solar collector. The engineering equation solver (EES) is employed for the mathematical modeling and simulation of the solar integrated system. The various operating parameters (beam radiation, inlet and ambient temperatures of heat transfer fluid, mass flow rate of heat transfer fluid, evaporator temperature, and generator temperature) are varied to analyze their influence on the performance parameters (power output, overall energetic and exergetic efficiencies, outlet temperature of the receiver, and as coefficient of performance (COP) and exergy efficiencies) of the integrated system. The results show that the overall energy and exergy efficiencies are observed to be 39.9% and 42.95% at ambient temperature of 27 °C and solar irradiance of 1000 W/m². The outlet temperature of the receiver is noticed to decrease from 1008 K to 528 K for an increase in the mass flow rate from 0.01 to 0.05 kg/s. The efficiency rate of the power plant is 38%, whereas COP of single effect absorption system is 0.84, and it will decrease from 0.87 to 0.79. However, the evaporator load is decreased to approximately 9.7% by increasing the generator temperature from 47 °C to 107 °C.