In recent years, the discrete element method (DEM) has gradually been applied to the traditional fluidization simulation of fine particles in a micro fluidized bed (MFB). The application of DEM in the simulating fast fluidization of fine particles in MFB has not yet received attention. This article presents a drag model that relies on the surrounding environment of particles, namely the particle circumstance-dependent drag model or PCDD model. Fast fluidization in an MFB of fine particles is simulated using DEM based on the PCDD model. Simulations indicate that the local structure in an MFB exhibits particle aggregation, which is a natural property of fast fluidization, forming a structure where a continuous dilute phase and dispersed concentrated phase coexist. There exists a strong effect of solid back-mixing in an MFB, leading to relatively low outlet solid flux. The gas back-mixing effect is, however, not so distinct. The axial porosity shows a monotonically increasing distribution with the bed height but does not strictly follow the single exponential distribution. The solid volume fraction at the bottom of the bed is significantly lower than the correlated value in CFB. The axial heterogeneous distribution of the cross-sectional average porosity in the lower half of the bed is also weakened. The radial porosity shows a higher distribution pattern in the central region and a lower one in the sidewall region.
16 March 2023 in Computers & Mathematics with Applications
This paper presents a level set function, named shape function, to describe and treat the irregular surface of mold cavity. With the aid of the shape function, the continuity, momentum and energy equations can be extended for solving two-phase flows with an immersed solid surface. The governing equations are solved by using the finite volume solver with the coupled level set and volume of fluid (CLSVOF) method to track the polymer melt front. As case studies, the melt filling processes are simulated in mold cavities with cylindrical insets. The numerical results show that the mathematical model can successfully depict the phenomenon of race-tracking and fountain, which are very helpful for determining processing conditions and designing mold cavities.