Traffic merging in urban environments is one of the main causes of traffic congestion. From the driver's point of view, the difficulty arises along the on-ramp where the merging vehicle's driver has to discern whether he should accelerate or decelerate to enter the main road. In parallel, the drivers of the vehicles already on the major road may have to modify their speeds to permit the entrance of the merging vehicle, thus affecting the traffic flow. This paper presents an approach to merging from a minor to a major road in congested traffic situations. An automated merging system that was developed with two principal goals, i.e., to permit the merging vehicle to sufficiently fluidly enter the major road to avoid congestion on the minor road and to modify the speed of the vehicles already on the main road to minimize the effect on that already congested main road, is described. A fuzzy controller is developed to act on the vehicles' longitudinal control - throttle and brake pedals - following the references set by a decision algorithm. Data from other vehicles are acquired using wireless vehicle-to-infrastructure (V2I) communication. A system installed in the infrastructure that is capable of assessing road traffic conditions in real time is responsible for transmitting the data of the vehicles in the surrounding area. Three production vehicles were used in the experimental phase to validate the proposed system at the facilities of the Centro de Automática y Robótica with encouraging results.

Vehicles equipped with intelligent systems designed to prevent accidents, such as collision warning systems (CWSs) or lane-keeping assistance (LKA), are now on the market. The next step in reducing road accidents is to coordinate such vehicles in advance not only to avoid collisions but to improve traffic flow as well. To this end, vehicle-to-infrastructure (V2I) communications are essential to properly manage traffic situations. This paper describes the AUTOPIA approach toward an intelligent traffic management system based on V2I communications. A fuzzy-based control algorithm that takes into account each vehicle's safe and comfortable distance and speed adjustment for collision avoidance and better traffic flow has been developed. The proposed solution was validated by an IEEE-802.11p-based communications study. The entire system showed good performance in testing in real-world scenarios, first by computer simulation and then with real vehicles.

The aim of this work was twofold: on the one hand, to describe a comparative study of two intelligent control techniques-fuzzy and intelligent proportional-integral (PI) control, and on the other, to try to provide an answer to an as yet unsolved topic in the automotive sector-stop-and-go control in urban environments at very low speeds. Commercial vehicles exhibit nonlinear behavior and therefore constitute an excellent platform on which to check the controllers. This paper describes the design, tuning, and evaluation of the controllers performing actions on the longitudinal control of a car-the throttle and brake pedals-to accomplish stop-and-go manoeuvres. They are tested in two steps. First, a simulation model is used to design and tune the controllers, and second, these controllers are implemented in the commercial vehicle-which has automatic driving capabilities-to check their behavior. A stop-and-go manoeuvre is implemented with the two control techniques using two cooperating vehicles.