Functionalized nanoporous materials have been developed recently as bio/chemical sensing materials. Due to the huge specific surface of the nano-materials for molecular adsorption, high hopes have been placed on gravimetric detection with micro/nano resonant cantilevers for ultra-sensitive sensing of low-concentration bio/chemical substances. In order to enhance selectivity of the gravimetric resonant sensors to the target molecules, it is crucial to modify specific groups onto the pore-surface of the nano-materials. By loading the nanoporous sensing material onto the desired region of the mass-type transducers like resonant cantilevers, the micro-gravimetric bio/chemical sensors can be formed. Recently, such micro-gravimetric bio/chemical sensors have been successfully applied for rapid or on-the-spot detection of various bio/chemical molecules at the trace-concentration level. The applicable nanoporous sensing materials include mesoporous silica, zeolite, nanoporous graphene oxide (GO) and so on. This review article focuses on the recent achievements in design, preparation, functionalization and characterization of advanced nanoporous sensing materials for micro-gravimetric bio/chemical sensing.

In a chamber-based digital PCR (dPCR) chip fabricated with polydimethylsiloxane (PDMS), bubble generation in the chambers at high temperatures is a critical issue. Here, we found that the main reason for bubble formation in PDMS chips is the too-high saturated vapor pressure of water at an elevated temperature. The bubbles should be completely prevented by reducing the initial pressure of the system to under 13.6 kPa to eliminate the effects of increased-pressure water vapor. Then, a cavity was designed and fabricated above the PCR reaction layer, and Parylene C was used as a shell covering the chip. The cavity was used for the negative generator in sample loading, PDMS degassing, PCR solution degassing in the digitization process and water storage in the thermal reaction process. The analysis was confirmed and finally achieved a desirable bubble-free, fast-digitization, valve-free and no-tubing connection dPCR.

The thermal expansion of gas and the air permeability of polydimethylsiloxane (PDMS) were previously thought to be the main causes of bubbles and water loss during polymerase chain reaction (PCR), resulting in a very complex chip design and operation. Here, by calculating and characterizing bubble formation, we discovered that water vapor is the main cause of bubbling. During PCR, heat increases the volume of the bubble by a factor of only ~0.2 in the absence of water vapor but by a factor of ~6.4 in the presence of water vapor. In addition, the phenomenon of “respiration” due to the repeated evaporation and condensation of water vapor accelerates the expansion of bubbles and the loss of water. A water seal above 109 kPa can effectively prevent bubbles in a bare PDMS chip with a simple structure, which is significant for the wide application of PDMS chips.

Multi-organ chips are effective at emulating human tissue and organ functions and at replicating the interactions among tissues and organs. An arrayed brain–heart chip was introduced whose configuration comprises open culture chambers and closed biomimetic vascular channels distributed in a horizontal pattern, separated from each other by an endothelial barrier based on fibrin matrix. A 300 μm-high and 13.2 mm-long endothelial barrier surrounded each organoid culture chamber, thereby satisfying the material transport requirements. Numerical simulations were used to analyze the construction process of fibrin barriers in order to optimize the structural design and experimental manipulation, which exhibited a high degree of correlation with experiment results. In each interconnective unit, a cerebral organoid, a cardiac organoid, and endothelial cells were co-cultured stably for a minimum of one week. The permeability of the endothelial barrier and recirculating perfusion enabled cross talk between cerebral organoids and cardiac organoids, as well as between organoids and endothelial cells. This was corroborated by the presence of cardiac troponin I (cTnI) in the cerebral organoid culture chamber and the observation of cerebral organoid and endothelial cells invading the fibrin matrix after one week of co-culture. The arrayed chip was simple to manipulate, clearly visible under a microscope, and compatible with automated pipetting devices, and therefore had significant potential for application.