This study evaluates the electrochemical hydrogen charging behavior and interaction between hydrogen and the microstructure of a duplex stainless steel. A saturation level of approximately 650 wppm is reached after 10 d of charging. The data are compared with a model resulting in a diffusion coefficient of 2.1 × 10−14 m2/s. A two-step increase of the concentration is observed and ascribed to saturation of ferrite followed by charging of austenite grains. Microstructural changes are observed during charging, i.e., formation and interaction of dislocations, as a result of the high residual stresses inherent to the production process of duplex stainless steels.
7 September 2022 in Materials Science and Engineering: A
Thermal desorption spectroscopy (TDS) was performed on ultra-low carbon (ULC) steel with various degrees of hydrogen-induced damage and deformation-induced defects. First, the extent to which hydrogen-induced damage manifests itself in TDS measurements was evaluated. Application of multiple test conditions on cold deformed ULC steel with and without the presence of hydrogen-induced damage showed that such damage did not appear as a hydrogen signal on the TDS spectra. Second, interesting features observed on the TDS spectra of cold deformed ULC steel were further investigated by assessing the TDS spectra of recrystallised and annealed ULC steel. As such, the four peaks in the TDS spectra were linked to microstructural features: interstitial lattice positions, grain boundaries, dislocations and microvoids.