Dekai Zhang

Dr. Dekai Zhang


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 December 2023 in Buildings
Verified
Journal Article
Open access
PDF file
XHXiaoyi Hu
Xiaoyi Hu
ZLZENG Liang
ZENG Liang
Hao WuHao Wu
Hao Wu
ADAbderrahim DJERRAD
Abderrahim DJERRAD
CYChenhan Yang
Chenhan Yang
DZDekai Zhang
Dekai Zhang
High-strength reinforcement is an important direction in the development of civil engineering. In order to fill the gap that the current concrete structure code GB50010 has no standard regulations applicable to HRB600-grade high-strength reinforcement, this paper conducted an experimental investigation on the crack width of eight concrete beams reinforced with HRB600-grade high-strength reinforcement. The study examined various parameters to understand the crack development process, crack spacing, and factors influencing crack width in the pure bending section. The results revealed that the damage mode and crack development process of high-strength reinforced concrete beams were similar to those observed in ordinary reinforced concrete bending members. The crack spacing in the pure bending section was independent of the concrete strength, and the average crack width in the pure bending section exhibited a proportional relationship with the reinforcement strain. Moreover, both were mathematically related to the ratio of reinforcement diameter and ratio. A calculation formula for the maximum crack width suitable for HRB600-grade reinforced concrete beams was developed and fit. The HRB600-grade high-strength reinforcement had an obvious yield stage and good ductility, and the test study provides a powerful reference for promoting the application of high-strength reinforcement in concrete structures.

16 January 2024 in Buildings
Verified
Journal Article
Open access
PDF file
XHXiaoyi Hu
Xiaoyi Hu
BZBaojun Zhao
Baojun Zhao
Hao WuHao Wu
Hao Wu
ADAbderrahim DJERRAD
Abderrahim DJERRAD
DZDekai Zhang
Dekai Zhang
Prefabricated structures are widely used because of their advantages of energy savings, environmental protection, standardization, and universality. However, due to the complex structure of the joints, it is easy to make the joint installation difficult and the prefabricated column connection unreliable, and further lead to the poor seismic performance of the structure. Therefore, a new type of dry sleeve joint with double screw sleeve without support is proposed, and the seismic performance and influencing factors of the new dry-sleeve-joint prefabricated column are studied. This study encompasses seven reinforced concrete columns characterized by cross-sectional dimensions of 600 mm × 600 mm. Among these, five specimens feature a novel dry sleeve connection, while the remaining two specimens were entirely cast-in-place. Low-cycle reversed loading experiments were conducted on all specimens to analyze and compare the damage patterns, hysteresis curves, skeleton curves, displacement ductility, energy dissipation capacity, and ultimate bearing capacity between precast and cast-in-place columns. Several parameters, including fabrication method, axial compression ratio, longitudinal reinforcement diameter, and hoop spacing, were examined. The findings demonstrated that the calculated-to-tested ratio of the ultimate bearing capacity for the prefabricated specimens was determined to be 0.62, indicating a high level of safety. The displacement ductility coefficient for each specimen ranged from 2.43 to 3.31, while the ultimate drift ratio was within the range of 1/41 to 1/33, satisfying the specified requirements for seismic performance. However, the hysteresis curve of the prefabricated specimens exhibited a pinching effect, which may be related to the existence of a weak layer on the joint surface of the post-cast section. In general, the shape of the new dry sleeve is maintained in the test, the connection form can effectively transfer the force, and the longitudinal bars can be strained and yield when the prefabricated column reaches the peak load. The new type of dry sleeve connection can be used for longitudinal reinforcement connection of reinforced concrete columns with seismic design.