Nanostructured cemented carbides with Co binders have shown excellent mechanical properties in various applications. Nevertheless, their corrosion resistance has shown to be insufficient in different corrosive environments, leading to premature tool failure. In this study, WC-based cemented carbide samples with different binders were produced using 9 wt% of FeNi or FeNiCo with the addition of Cr₃C₂ and NbC as the grain growth inhibitors. The samples were investigated using electrochemical corrosion techniques: the open circuit potential E_corr, the linear polarization resistance (LPR), the Tafel extrapolation method, and the electrochemical impedance spectroscopy (EIS) at room temperature in the solution of 3.5% NaCl. Microstructure characterization, surface texture analysis, and instrumented indentation were conducted to investigate the influence of corrosion on the micro-mechanical properties and the surface characteristics of the samples before and after corrosion. The obtained results indicate a strong binder chemical composition’s effect on the consolidated materials’ corrosive behavior. Compared to the conventional WC-Co systems, a significantly improved corrosion resistance was observed for both alternative binder systems. The study shows that the samples with the FeNi binder are superior to those with the FeNiCo binder since they were almost unaffected when exposed to the acidic medium.

Drill bits with internal cooling capabilities are still not employed in stone machining practices within shop floor environments. Therefore, a conventional industrial drill bit used in stone machining was subject to a redesign wherein an axial cooling channel was machined throughout its body. A comparison was drawn between the standard drill bit without cooling capabilities and the redesigned drill bit, which used compressed air as a cooling medium. The experiment was performed by drilling three types of stone samples varying in hardness with nine combinations of cutting speed and feed rate. During the machining process, two types of process signals were continuously measured—namely, cutting forces and vibrations. Additionally, the cutting edges of the drill bits were inspected after a specific number of drilling cycles using a vision system. The primary objective of this study was to compare the cutting forces and tool wear dynamics achieved by those two drill bits. Furthermore, the usage of vibration signals in the classification of stone hardness during machining with an internally cooled drill bit was additionally analyzed. The results of this study unveiled improvement in minimizing cutting forces, vibrations, and the intensity of tool wear when utilizing an internally cooled drill bit. Even though the machining system generally exhibited lower vibrations, vibration signals again demonstrated commendable efficacy in classifying stone hardness.

This paper presents a control system design methodology for the drill-string rotary drive and draw-works hoist system aimed at mature drilling rig retrofitting. The rotary drive is equipped with an active damping speed control system...