In this study, the temperature–pressure separation technique was used to successfully obtain the process of the unsymmetrical dimethylhydrazine droplet diameter variation with time during evaporation in subcritical, supercritical, and far-supercritical environments at temperatures and pressures of 473–773 K and 1–9 MPa, respectively. The results show that unsymmetrical dimethylhydrazine droplet evaporation has two characteristic stages, transient heating and steady-state evaporation, under low-pressure and low-temperature environments; the steady-state evaporation stage influences droplet evaporation life more than the transient heating stage. Under high-pressure and high-temperature environments, droplet evaporation shows only a single feature of steady-state evaporation, and the droplet expansion process in the transient heating stage disappears. The normalized droplet lifetime decreased exponentially with temperature and decreased linearly and monotonically with pressure. The evaporation rate constant increases linearly and monotonically with temperature and exponentially with pressure.
The evaporation characteristics of unsymmetrical dimethylhydrazine droplets with different initial diameters in a subcritical environment were experimentally investigated with the temperature–pressure separation technique. The evaporation processes of unsymmetrical dimethylhydrazine droplets with different initial diameters in this environment have the same general pattern. All the studied droplets exhibit a short transient heating phase and a steady-state evaporation phase obeying . Notably, the expansion of the transient heating phase gradually increases with increasing ambient pressure. The change in diameter squared increases from 1.03% at 1 MPa to 12.48% at 5 MPa. Under subcritical conditions, the evaporation rate decreases linearly with decreasing droplet diameter, and the droplet evaporation lifetime increases linearly. Changes in the initial droplet diameter may still have a large effect on droplets smaller than those studied here. When the ambient pressure is not greater than 3 MPa, the change in the steady-state evaporation time for both medium- and large-diameter droplets accounts for more than 70% of the variation in the droplet evaporation lifetime. As the ambient pressure increases to 4 MPa and 5 MPa, the percentage of the change in the transient heating time contributing to the variation in the droplet evaporation lifetime gradually increases to more than 45%.