To overcome the space-time adaptive processing (STAP) performance loss caused by discarding the non-uniform parts of difference coarray and copulse for coprime sampling structure under the condition of single-frequency operation, this paper proposes a new STAP algorithm to improve the precision of filter weight vector estimation by the dual-frequency operation. By selecting a single proper additional operation frequency, we can obtain the different coarray and copulse, thus fill two missed virtual sensors and pulses of the difference structures in the single-frequency operation simultaneously. Compared with the single-frequency operation, the dual-frequency operation method can acquire the bigger uniform linear array (ULA) and coherent processing interval (CPI) pulse train to improve the system degrees of freedom (DOF), and result in higher angle-Doppler resolution. In addition, the coprime array has the little mutual coupling effect because of the larger inter-sensors spacing. Therefore, the resulting method can alleviate mutual coupling and enhance the system DOF.
In radar systems, element gain-phase errors can degrade the performance of space–time adaptive processing (STAP), and even cause complete failure. To address this issue, the STAP with the coprime sampling structure based on optimal singular value thresholding is proposed. The algorithm corrects errors by adding four calibrated auxiliary elements and auxiliary pulses to the original array and pulse sequence, while maintaining the coprime sampling structure. The corrected virtual clutter covariance matrix (CCM) is then expanded and filled with holes. Subsequently, the optimal singular value thresholding method is used to restore the CCM. Simulation results demonstrate that the proposed algorithm shows advantages in convergence speed, detection probability, and stability.
22 December 2020 in Mathematical Problems in Engineering
We consider the problem of clutter covariance matrix (CCM) estimation for space-time adaptive processing (STAP) radar in the small sample. In this paper, a fast efficient algorithm for CCM reconstruction is proposed to overcome this shortcoming for the linear structure. Particularly, we present a low-rank matrix recovery (LRMR) question about CCM estimation based on the Toeplitz structure of CCM and the prior knowledge of the noise. The closed-form solution is obtained by relaxing the nonconvex LRMR problem that the trace norm replaces the rank norm. The target can then be efficiently detected by using the recovered CCM according to the STAP theorem. We also analyze the algorithm model under the linear structure in the presence of unknown mutual coupling. It is shown that our method can obtain accurate CCM in the small sample, with even higher accuracy than the traditional algorithms in the same number of samples. It also can reduce the coupling effect and obtain more degrees of freedom (DOF) with limited sensors and pulses by utilizing sparse linear structure (SLS) and improve angle and Doppler resolutions. Finally, numerical simulations have verified the effectiveness of the proposed method in comparison with some of the existing methods.
A miniaturized metamaterial-based tri-band antenna is proposed, which achieves multi-band coverage and performance enhancement through innovative structural design. The compact geometry is realized by integrating short-circuit stubs, significantly reducing the physical footprint. By synergistically combining the reconstruction of the negative first-order resonance mode with an additional resonance point, the operational bandwidth is effectively broadened to fully cover three key communication bands: 2.4–2.6, 3.3–3.8, and 5.2–5.8 GHz. The antenna employs a coplanar waveguide fed structure, incorporating a metamaterial unit cell and a grounded rectangular patch on a monopole configuration. This design improves the front-to-back ratio of the radiation pattern and achieves cross-polarization suppression better than −25 dB. Experimental verification shows that while maintaining a compact size, this antenna has excellent impedance matching characteristics and stable gains in each frequency band. Simulation and measurement results indicate that it meets the performance requirements of modern multi-standard wireless communication systems for compact multi-frequency antennas.