The shear behavior of the Bolt-Grout interface has a significant effect on the stability of a bolting system. In this paper, a series of shear tests were conducted on Bolt-Grout interfaces, and the effects of rib spacing, rib angles, and normal stress on the shear characteristics and failure modes of the Bolt-Grout interface were investigated. The results showed that the shear strength varied nonlinearly with an increase in rib spacing and angle, and also that it increased linearly with an increase in normal stress. With smaller rib spacings, the effect of rib spacing on peak shear strength was more apparent. The failure modes of the interface can be categorized as shear-slip failure, shear-break failure, and composite failure. The proportion of shear-slip failure and shear-break failure mainly depends on the rib spacing, rib face angle and normal stress.

Filled joints are widely found in natural rock masses and are one of the main factors causing rock mass engineering instability. The use of bolts can effectively control the shear slip of filled joints, research on bolts filled joints in the filling degree, and other key parameters of the influence of the law, to ensure the stability of the engineering rock body is of great significance. This paper presents shear experiments on bolted filled joints of Basalt Fiber-Reinforced Polymer (BFRP) materials with different joint roughness and filling degrees, while acoustic emission technology monitors the shear failure process of the specimens. The results show that the peak shear strength decreases with the increase in filling degree, and the peak shear strength decreases by 23.9% when the filling degree changes from 0 to 2.0 at 4 MPa and J2 conditions, while the normal stress, the Joint Roughness Coefficient (JRC) and the peak shear strength both show a positive correlation. The normal deformation of bolted filled joints exhibits three distinct evolutionary patterns depending on the filling degree, while both JRC and normal stress significantly influence the magnitude of shear dilatancy-shrinkage deformation. The shear resistance of BFRP bolts is mainly reflected in the post-peak plastic stage, and some of the fibers break during its shear deformation to form controlled yielding, with vertical and horizontal deformation controlled within 15.5~22.3 mm and 4.7~6.9 mm, respectively. The Acoustic Emission (AE) results show that the AE events are mainly in the post-peak plasticity stage, and the proportion is about the sum of the proportion of the other two phases, and this proportion increases with the increase in the filling degree.