The major concern of the present research is degradation of hazardous and stable Indigo dye used in industrial denim dying process. For this purpose, a heterogeneous photocatalysis process was carried out to treat aqueous solution of Indigo dye using pure titanium dioxide (TiO2) in a batch reactor system under ultraviolet A (UVA) light for 210 min. In the study, individual and synergistic effects of factors such as TiO2 dosage, pH, and initial dye concentration were scrutinized. Moreover, Taguchi statistical method was performed to optimize influential parameters. The results obtained from the study that TiO2 concentration had the most effective factor on the Indigo dye degradation. The optimal conditions for dye removal were A (pH) at level 2 (4), B (initial dye concentration) at level 1 (10 mg/L) and C (TiO2 concentration) at level 4 (1.5 g/L). The results presented that the theoretically predicted value for degradation efficiency (100%) was confirmed by the experimental value (100%).
2 August 2022 in Polish Journal of Environmental Studies
This study compares the removal performances of sonocatalysis (SC) coupled with commercially available titanium dioxide (TiO2, P25) and combined sonophotocatalysis (SPC) with H2O2 of 2,4-dichlorophenoxyacetic acid (2,4-D) herbicide in aqueous media in batch experiments. A SC process (US/TiO2) with 75 mg/L 2,4-D obtained 65.58 ±0.42% degradation, 7.84 ±1.3% mineralization, and 15.86 ±0.39% oxidation at a pH of 2, and a temperature of 35±1ºC under optimum conditions after 360 minutes, whereas 82.24±2.91% degradation, 44.50 ±0.11% mineralization, and 55.11±0.35% oxidation were obtained after 360 minutes with SPC (US/UVA/TiO2-H2O2), with the addition of an optimum 250 mg/L of H2O2. The synergistic index was calculated as 1.77 that indicated the positive effect of the combined system on degradation efficiency when compared with the individual processes. Total costs were obtained as 5072 USD/kg for SC and 4135 USD/kg for SPC, showing the cost efficiency of the hybrid SPC process in comparison to the SC process. The obtained results confirmed that the hybrid SPC process was more effective than the SC process in degrading and mineralizing 2,4-D for removal. Operation time was shorter, energy consumption was lower, and operation cost was lower when compared to the SC process.
30 September 2019 in Environmental Research and Technology
Microalgal lipid is a major natural feedstock for biodiesel production. However, microalgae-based biofuel technology comes with obstacles to production, such as high investment and operating costs. To overcome these problems, nowadays some strategies have been used during cultivation stage of the microalgae for enhancing biomass and accumulate lipids and carbohydrates which could be used for biofuel production. The most common methods applied to microalgae are classified as nutrient stress and changes in growth conditions that lead to increase the lipid content in the species without decreasing the growth rate of their potential strains or by simultaneously increasing both of these. Scenedesmus sp. are considered to be the most appropriate microalgae to culture commercially due to their high biomass, lipid and carbohydrate yield. The purpose of this review was to describe nutrient stress strategy to develop biofuels as a sustainable alternative to fossil fuels and, in particular, with respect to nitrogen nutrient limitations, the lipid yield and biomass development in Scenedesmus sp. microalgae. The nitrogen starvation/limitation strategy that will increase the general economic feasibility of microalgal lipid production and affect the fatty acid composition was presented.
29 August 2022 in Desalination and Water Treatment
The critical roles of recycling are increasing depending on depleted natural resources and its devastating consequences. Concrete has been one of the most used building materials for many years to response the basic need of human beings for shelter. The studies on the recycling of concrete are crucial to minimize negative effects of both the high amount of energy consumed during the production phase and the limited recycling opportunities after destruction. Considering the amount of construction and demolition waste (CDW) after the February 6, 2023 earthquakes in Türkiye, it is clear that recycling concrete (RC) may make a positive contribution to environmental sustainability and natural resources usage. In addition, as a result of the ongoing urban transformation projects throughout Türkiye, especially in Istanbul, there is a need to recycle CDW, the majority of which consists of concrete. This paper examines the equivalent CO2 emissions of recycled concrete aggregate (RCA) incorporation of various proportion fly ash and hemp based on previous studies by applying the Excel-based GreenConcrete LCA software developed at the University of California Berkeley Campus (UC Berkeley). As a result of the investigations, it is seen that the use of RCA, which is generated in large quantities both as a result of earthquakes and urban transformation projects, reflects positively on the environmental impacts in the LCA analysis. In addition, the use of concrete mixtures that contribute to the recycling of wastes such as fly ash and hemp used as admixtures contributes to reducing the environmental damage of these wastes and improving the concrete content.