Spinel ferrite nanoparticles represent a class of magnetic nanoparticles (MNPs) with enormous potential in magnetic hyperthermia. In this study, we investigated the magnetic and heating properties of spinel soft NiFe₂O₄, MnFe₂O₄, and hard CoFe₂O₄ MNPs of comparable sizes (12–14 nm) synthesized by the polyol method. Similar to the hard ferrite, which predominantly is ferromagnetic at room temperature, the soft ferrite MNPs display a non-negligible coercivity (9–11 kA/m) arising from the strong interparticle interactions. The heating capabilities of ferrite MNPs were evaluated in aqueous media at concentrations between 4 and 1 mg/mL under alternating magnetic fields (AMF) amplitude from 5 to 65 kA/m at a constant frequency of 355 kHz. The hyperthermia data revealed that the SAR values deviate from the quadratic dependence on the AMF amplitude in all three cases in disagreement with the Linear Response Theory. Instead, the SAR values display a sigmoidal dependence on the AMF amplitude, with a maximum heating performance measured for the cobalt ferrites (1780 W/g_Fe+Co), followed by the manganese ferrites (835 W/g_Fe+Mn), while the nickel ferrites (540 W/g_Fe+Ni) present the lowest values of SAR. The heating performances of the ferrites are in agreement with their values of coercivity and saturation magnetization.

We report the synthesis of magnetite nanoparticles (IOMNPs) using the polyol method performed at elevated temperature (300 °C) and high pressure. The ferromagnetic polyhedral IOMNPs exhibited high saturation magnetizations at room temperature (83 emu/g) and a maximum specific absorption rate (SAR) of 2400 W/g_Fe in water. The uniform dispersion of IOMNPs in solid matrix led to a monotonous increase of SAR maximum (3600 W/g_Fe) as the concentration decreased. Cytotoxicity studies on two cell lines (cancer and normal) using Alamar Blues and Neutral Red assays revealed insignificant toxicity of the IOMNPs on the cells up to a concentration of 1000 μg/mL. The cells internalized the IOMNPs inside lysosomes in a dose-dependent manner, with higher amounts of IOMNPs in cancer cells. Intracellular hyperthermia experiments revealed a significant increase in the macroscopic temperatures of the IOMNPs loaded cell suspensions, which depend on the amount of internalized IOMNPs and the alternating magnetic field amplitude. The cancer cells were found to be more sensitive to the intracellular hyperthermia compared to the normal ones. For both cell lines, cells heated at the same macroscopic temperature presented lower viability at higher amplitudes of the alternating magnetic field, indicating the occurrence of mechanical or nanoscale heating effects.

Copper is one of the most used therapeutic metallic elements in biomedicine, ranging from antibacterial approaches to developing new complexes in cancer therapy. In the present investigation, we developed a novel xCuO∙(100 − x) [CaF₂∙3P₂O₅∙CaO] glass system with 0 ≤ x ≤ 16 mol% in order to determine the influence of doping on the composition structure of glasses. The samples were characterized by dissolution tests, pH measurements, Fourier-transform infrared spectroscopy (FT-IR), electron paramagnetic resonance (EPR), Scanning Electron Microscopy with energy dispersive spectroscopy (SEM-EDX) and afterward, their antitumor character was assessed. The glasses were mostly soluble in the aqueous medium, their dissolution rate being directly proportional to the increase in pH and the level of doping up to x = 8 mol%. FT-IR spectra of glass samples show the presence of all structural units characteristic to P₂O₅ in different rates and directly depending on the depolymerization process. SEM-EDX results revealed the presence of an amorphous glass structure composed of P, O, Ca, and Cu elements. The 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT) reduction assay showed strong cytotoxicity for tumoral cells A375 even in low concentrations for Cu-treatment. In contrast, the copper-free matrix (without Cu) determined a proliferative effect of over 70% viability for all concentrations used.

In this research, we investigated the structural and biological properties of phosphate glasses (PGs) after the addition of V₂O₅. A xV₂O₅∙(100 − x)[CaF₂∙3P₂O₅∙CaO] glass system with 0 ≤ x ≤ 16 mol% was synthesized via a conventional melt-quenching technique. Several analysis techniques (dissolution tests, pH, SEM-EDS, FT-IR, and EPR) were used to obtain new experimental data regarding the structural behavior of the system. In vitro tests were conducted to assess the antitumor character of V₂O₅-doped glass (x = 16 mol%) compared to the matrix (x = 0 mol%) and control (CTRL-) using several tumoral cell lines (A375, A2780, and Caco-2). The characterization of PGs showed an overall dissolution rate of over 90% for all vitreous samples (M and V1–V7) and the high reactivity of this system. EPR revealed a well-resolved hyperfine structure (hfs) typical of vanadyl ions in a C_4v symmetry. FT-IR spectra showed the presence of all structural units expected for P₂O₅, as well as very clear depolymerization of the vitreous network induced by V₂O₅. The MTT assay indicated that the viability of tumor cells treated with V7-glass extract was reduced to 50% when the highest concentration was used (10 µg/mL) compared to the matrix treatment (which showed no cytotoxic effect at any concentration). Moreover, the matrix treatment (without V₂O₅) provided an optimal environment for tumor cell attachment and proliferation. In conclusion, the two types of treatment investigated herein were proven to be very different from a statistical point of view (p < 0.01), and the in vitro studies clearly underline the cytotoxic potential of vanadium ions from phosphate glass (V7) as an antitumor agent.

Cyclodextrins (CDs) are macrocycles that are well suited for forming inclusion complexes for surface-enhanced Raman scattering (SERS) detection of analytes due to their low Raman activity, which minimizes background SERS signals and enhances the detection of target molecules without interference. In this paper, we systematically investigated the synthesis of both silver (Ag) and gold (Au) nanoparticles (NPs) using CDs as reducing and capping agents in a basic environment using microwave (MW), ultrasound (US), and room temperature (RT) synthesis. We found that replacing NaOH with K₂CO₃ as an alkaline environment almost doubles the size (from <10 nm to around 20 nm) of AgNPs in the MW-assisted synthesis. Synthesis using the US produces less stable particles due to the sample evolution after US irradiation. Ag (20 nm) and Au (11 nm) were successfully obtained at room temperature in the presence of CDs and K₂CO₃. All synthesized particles present SERS activity. CD capping allowed us to detect hydrophobic molecules like naphthalene and melamine. In the case of methylene blue, the CD capping prevents the changes induced in the SERS by a basic pH. We also demonstrate that the newly synthesized NPs can discriminate by SERS the propranolol enantiomers. Moreover, propranolol inclusion in CDs leads to a dramatic change in its SERS spectrum.

Early enamel lesions result from pH imbalance in the oral cavity, causing subsurface de-mineralization. Resin infiltration has emerged as a minimally invasive treatment option that can halt lesion progression, filling and stabilizing enamel while improving esthetics and microhardness. Raman spectroscopy provides rapid, non-destructive analysis of enamel by detecting molecular vibrations that reflect its chemical composition and structural changes. It allows efficient characterization and depth profiling of dental tissues and materials. Raman spectra also enable quantitative assessment of compositional and structural alterations within enamel. This study aimed to assess the penetration depth of two experimental infiltration materials and a commercial resin within incipient demineralization enamel lesions using Raman spectroscopy. Artificial enamel lesions were created on three extracted human teeth. The samples were treated with a commercial resin infiltrate and two experimental resin infiltrates, with a modified recipe, following the manufacturer’s protocol. Each tooth was sectioned into a 1 mm thick disk. Raman spectra were recorded at sequential depths across both the control (untreated) and infiltrated surfaces of each disk. Characteristic peaks corresponding to infiltrate’s organic matrix and enamel’s phosphate and carbonate groups were employed for assessing penetration depth.