In this study, Al2O3–siloxane composite thermal pads were fabricated using a tape–casting technique, and the thermal conductivity effect of the Al2O3 nanoparticle powder synthesized using a flame fusion process on siloxane composite thermal pads was investigated. Furthermore, various case studies were implemented, wherein the synthesized Al2O3 nanoparticle powder was subjected to different surface treatments, including dehydration, decarbonization, and silylation, to obtain Al2O3–siloxane composite thermal pads with high thermal conductivity. The experimental results confirmed that the thermal conductivity of the Al2O3–siloxane composite pads improved when fabricated using surface–treated Al2O3 nanoparticle powder synthesized with an optimally spheroidized crystal structure compared to that produced using non–treated Al2O3 nanoparticle powder. Therefore, this study provides guidelines for fabricating Al2O3–siloxane composite thermal pads with high thermal conductivity in the field of thermal interface materials.
The structural defect effect of impurities on silicon carbide (SiC) was studied to determine the luminescence properties with temperature-dependent photoluminescence (PL) measurements. Single 4H-SiC crystals were fabricated using three different 3C-SiC starting materials and the physical vapor transport method at a high temperature and 100 Pa in an argon atmosphere. The correlation between the impurity levels and the optical and fluorescent properties was confirmed using Raman spectroscopy, X-ray diffraction, inductively coupled plasma atomic emission spectroscopy (ICP-OES), UV-Vis-NIR spectrophotometry, and PL measurements. The PL intensity was observed in all three single 4H-SiC crystals, with the highest intensities at low temperatures. Two prominent PL emission peaks at 420 and 580 nm were observed at temperatures below 50 K. These emission peaks originated from the impurity concentration due to the incorporation of N, Al, and B in the single 4H-SiC crystals and were supported by ICP-OES. The emission peaks at 420 and 580 nm occurred due to donor–acceptor-pair recombination through the incorporated concentrations of nitrogen, boron, and aluminum in the single 4H-SiC crystals. The results of the present work provide evidence based on the low-temperature PL that the mechanism of PL emission in single 4H-SiC crystals is mainly related to the transitions due to defect concentration.
The discoloration switching appearing in the initial and final growth stages of 4H-silicon carbide (4H-SiC) single crystals grown using the physical vapor transport (PVT) technique was investigated. This phenomenon was studied, investigating the correlation with linear-type micro-pipe defects on the surface of 4H-SiC single crystals. Based on the experimental results obtained using time-of-flight secondary ion mass spectrometry (ToF-SIMS) and micro-Raman analysis, it was deduced that the orientation of the 4H-SiC c-axis causes an axial change that correlates with low levels of carbon. In addition, it was confirmed that the incorporation of additional elements and the concentrations of these doped impurity elements were the main causes of discoloration and changes in growth orientation. Overall, this work provides guidelines for evaluating the discoloration switching in 4H-SiC single crystals and contributes to a greater understanding of this phenomenon.