Films of silicon nitride SiN x, obtained by plasma-enhanced chemical vapor deposition from the monosilane SiH4 and ammonia NH3gases, are widely used in microelectronics and micro- and...
In this paper, the experimental methodology for the single-crystal circular plate deformation measurement and subsequent procedure for the quantitation of its mechanical properties are developed. The procedure is based on a new numerical-analytical solution of non-linear boundary-value problem for finite deformations of a circular anisotropic plate. Using the developed method, a study of the deformation of single-crystal circular plates formed on the basis of a silicon-on-insulator structure was carried out. The values of residual stresses are determined and it is shown that the presence of these stresses increases the flexural rigidity of the plate by several times.
Experimental study of aluminum membranes on a silicon substrate was conducted. Different combinations of Al layers were formed by magnetron method. Thickness has been determined by scanning electron microscope and secondary ion mass spectrometer. The distribution of atoms in the depth of the material was shown. The border between single layers of aluminum was detected. The dependence of the surface roughness on the number of membrane layers was given. A method for assessing the mechanical strength of circular membranes has been developed. Influence of ion beam etching process on membrane mechanical strength investigated.
An analysis of the methods for calculating the dependence of the deflection of multilayer round membranes on the applied overpressure was carried out. To compare theoretical calculations with experimental data, as an example, we considered a round membrane based on the structure Al/SiO2/Al with a total thickness of 2.5 μm. Using the COMSOL Multiphysics and ANSYS software packages, we calculated the stress distribution in the radial and tangential directions, the distribution of equivalent von Mises stresses over the membrane area, and also compared the obtained numerical values of mechanical stresses with the corresponding analytical estimates. We compared the deflection of the membrane depending on the applied overpressure obtained using software packages, analytical estimates and records obtained experimentally using an optical profilometer. It was shown that, when studying the deflection of membranes, which significantly exceeds the thickness of the membranes, to predict the deformations expected in the experiment, analytical relations obtained taking into account the presence of tensile forces, radial displacement, and elongation of the median plane should be used.
1 March 2017 in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
A conceptual model of an X-ray source based on a field emission cathode and a transmission-type target combined with a silicon X-ray window is suggested. By numerical simulation, it is shown that the proposed structure can generate a substantial emission current. It is possible to obtain a small focal spot at the target and, therefore, a high resolution. The parameters of targets providing the maximum X-ray emission intensity are determined. It is shown that effective generation is reached in a 0.25-μm-thick tungsten film and a 0.13-μm-thick molybdenum film. The transparency of a 1–2-μm-thick silicon membrane to X-rays and sufficient mechanical strength of the membrane against a pressure drop on the order of 2 atm are demonstrated, which indicates the possibility of its application as an X-ray window.
The technology of forming blanks of nanostructured membranes for MEMS devices based on alternating Si3N4/SiO2layers with a nanometer thickness has been developed. A comprehensive study of the...