Space trusses are structural systems, generally made of tubes, used worldwide because of their advantages in covering long-span roofs. In addition to having a low cost, the truss weight is relatively reduced. The load capacity of these structures depends also on the strength of their node connection. Connections made with the superposition of flattened tube ends trespassed by one bolt are, generally, known as typical nodes. They are inexpensive but present eccentricities that reduce significantly the strength of such space trusses. To increase the truss load capacity, this research presents the results of an experimental program to reduce the eccentricities of the typical nodes. This reduction is done with a new type of spacer made of encapsulated concrete with steel fiber or sisal fiber. The experimental tests showed that the trusses with typical nodes collapsed under reduced load by local failure due to high distortions at the nodes. The trusses with encapsulated concrete spacer showed good results, with an increase in collapse load of 36% and failure by buckling bars.
1 August 2021 in Journal of Structural Engineering
Space trusses are extensively used to construct large free spans in roofs. In many countries, connections in such space trusses are made with tubes linked by typical space-truss connections. Typical nodes are made with the superposition of flattened tube ends significantly reducing the strength of such space trusses. This paper presents the use of natural sisal fiber and the reuse of recyclable tires to produce spacers to correct such typical nodes. The choice of those new materials reflects the growing interest in recycling, reducing, and reusing usable waste. There is increasing global environmental awareness of and social concern with the high rate of petroleum resource depletion as in tire manufacture. Moreover, the new environmental and sustainability regulations in engineering arouse interest in new and natural materials like sisal fibers. Therefore, in this paper, two new spacers are presented as an appropriate choice to reduce the eccentricity of typical connections in space trusses. The results of experimental and numerical tests show their efficiency in reducing the eccentricities of typical nodes, increasing the resistance capacity of space trusses with low cost materials. Finite-element (FE) results are compared with experimental results validating the advantages of using these new spacers in typical connections in space-truss nodes.
This paper shows an extensive study on the Typical Connections used in Double-Layer Space Truss. For this structural system, the ends of the bars are flattened to connect the bars. However, the flattening process results in a highly plastic stamping zone susceptible to warping with the appearance of two eccentricities, one of which causes rotation of the connection, with the presence of a bending moment with local rupture resulting in progressive collapse of the entire coverage system, as already evidenced in several countries. Therefore, eccentricity in this paper is studied and an analytical solution to the problem is presented through the use of a new device called a spacer. Furthermore, a preliminary study with complex numerical simulation was carried out with nonlinear analysis in ABAQUS were evaluated. For this study, nine space trusses were experimentally tested with reinforcement spacer in reduced trusses. After confirming the efficiency of the spacer proposal, another six space trusses were tested in the laboratory, this time, on a full-scale. In this study, two types of spacers were evaluated, one made of USI SAC 350 steel and another cheaper one made from recycled tires from heavy vehicles with multiple filaments of steel and nylon wires in the rubber layers. The two devices presented very close resistance capacity values, with a resistance gain of approximately 30% in relation to connections without reinforcement, with structural failure characterized by buckling of the bars. Finally, a numerical study of space trusses with spacers was developed. In practical design terms, from these FE simulations it was possible to determine the normal stresses for different spacers applied in the different modeled spans.