As a candidate anode material for Li-ion batteries, Bi-based materials have attracted extensive attention from researchers due to their high specific capacity, environmental friendliness, and simple synthesis methods. However, Bi-based anode materials are prone to causing large volume changes during charging and discharging processes, and the effect of these changes on lithium storage performance is still unclear. This work introduces that Bi/C nanocomposites are prepared by the Bi-based MOF precursor calcination method, and that the Bi/C nanocomposite maintains a high specific capacity (931.6 mAh g−1) with good multiplicative performance after 100 cycles at a current density of 100 mA g−1. The structural evolution of Bi/C anode material during the first cycle of charging and discharging is investigated using in situ synchrotron radiation SAXS. The SAXS results indicate that the multistage scatterers of Bi/C composite, used as an anode material during the first lithiation, can be classified into mesopores, interspaces, and Bi nanoparticles. The different nanostructure evolutions of three types of Bi nanoparticles were observed. It is believed that this result will help to further understand the complex reaction mechanism of Bi-based anode materials in Li-ion batteries.
1 February 2021 in Materials Chemistry and Physics
Silicon-based materials are considered the most promising next-generation anode materials for lithium-ion batteries due to their high theoretical specific capacity, rich reserves, and advantages of low discharge potential. However, the significant volume expansion of silicon during the cycling process leads to the detachment of active substances and the loss of electrical contact between the active substances and the current collector, ultimately resulting in a decline in battery performance. Nanostructured anodes have advantages of high specific surface area, short diffusion path, and the ability to effectively alleviate the volume expansion of electrode material during circulation. Therefore, how to rationally design the nanostructured silicon-based anodes is currently one of the research hotspots. This article first reviews and evaluates the advantages and disadvantages of microstructured and nano-structured silicon anodes in rate performance, discusses cycle stability and volumetric energy density, and discusses and summarizes the lithium storage mechanism of silicon-based materials, with a focus on the influence of some nanostructured silicon anodes and silicon/carbon composites and conductive polymers and silicon/metal composites on the electrochemical properties of materials. Finally, some suggestions and prospects for the future development of silicon-based materials are proposed.
The sharp increase of waste polyurethane rigid foam has caused great harm to the natural environment. Ethylene glycol (EG) and propylene glycol (PG) was the alcoholysis agents, and KOH and Zn3[Co(CN)6]2(DMC) were used as catalysts for alcoholysis of waste polyurethane rigid foam. Regenerated polyols were prepared. The effects of different catalysts on the infrared, viscosity and hydroxyl content of alcoholysis products were discussed. Regenerated polyurethane rigid foam was prepared from alcoholysis products and analyzed by compression strength, thermal conductivity, water absorption, scanning and thermogravimetry. The effects of different catalysts on the recycling of waste polyurethane rigid foam were studied. The experimental results show that DMC catalyst is more effective than KOH catalyst under the same conditions.The alcoholysis product of DMC system has lower viscosity and higher hydroxyl content, which is more suitable for the preparation of regenerated polyurethane rigid foam., The compressive strength of the prepared regenerated polyurethane rigid foam is 254 Kpa, and the thermal conductivity is 0.0213 W m−1·K−1 when the amount of DMC added is 0.04%. Meanwhile, the regenerated polyurethane rigid foam has good hydrophobicity, excellent heat preservation performance, complete cell morphology and good thermal stability. It can replace the traditional polyols to prepare the regenerated polyurethane material which meets the national standard ‘rigid polyurethane foam for building insulation’ (GB/ T21558-2005).
11 March 2021 in Journal of Physics and Chemistry of Solids
The electrochemical CO2 reduction reaction (CO2RR) is a promising approach for mitigating the greenhouse effect arising from anthropogenic CO2 emission. Nonetheless, poor product selectivity associated with electrochemical catalysts is the main technical problem for the application of CO2RR technology. The catalytic performance of nano-catalysts is strongly dependent on their microstructural features. Anomalous small-angle X-ray scattering (ASAXS) is one of the most effective techniques for studying nanostructural change in an operando way, especially for complex systems and mixed-element catalyst situations. Furthermore, based on the research results of ASAXS, appropriate catalyst components and nanostructures can be designed to achieve stable catalytic performance of the catalyst, promote catalytic reaction rate, or improve catalytic reaction selectivity. In this paper, the basic concept, principle, and applications in different systems of ASAXS are reviewed thoroughly. Finally, the development prospect of ASAXS in the field of electrocatalysis is prospected. It is hoped that this review will further promote ASAXS technology to play a more far-reaching impact in the field of electrocatalytic CO2RR.