Michael Fletcher

Mr. Michael Fletcher

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 January 2022 in IEEE Transactions on Vehicular Technology
Verified
Journal Article
Closed access
Alan MichaelsAlan Michaels
Alan Michaels
VPVenkata Sai Srikar Palukuru
Venkata Sai Srikar Palukuru
MFMichael Fletcher
Michael Fletcher
CHChristopher Henshaw
Christopher Henshaw
SWSteven Williams
Steven Williams
JMJohn Moore
John Moore
Over the past decade, consumer vehicles have increasingly begun to resemble computers on wheels, with many newer vehicles containing over 100 independent electronic control units (ECU) that make independent decisions within the vehicle. Cost and power constraints for the vehicle significantly constrain processing capabilities and limitations on practical cybersecurity measures that may be employed in the vehicle today. Also, as automotive manufacturers are continuous integrators, many legacy communications links within vehicles were originally designed as standalone entities that assumed internal trust of communications between ECUs by virtue of closed bus structures and an emphasis on reliability, but not security. This paper presents a low-cost authentication mechanism to significantly improve message validation on wired message buses such as the Controller Area Network (CAN) bus by employing a co-channel underlay watermark that arrives time-aligned with the primary bus messages. Concept validation using a gate-level Simulink / HDL Coder simulation provided initial feasibility, while a complete CAN bus hardware testbed was constructed with a custom CAN transceiver built on a Red Pitaya software defined radio (SDR) connected to multiple commercial CAN transceivers to validate backwards compatibility. This testbed incorporates a custom transmission security (TRANSEC) engine that supports dynamic variation of the watermark, further improving security during deployment. Finally, this custom CAN testbed with the watermarking CAN transceiver was tested across a range of operational conditions, with initial performance results presented and discussed. Future work describes potential for near-term ruggedization and productization of the watermarking CAN transceiver.

26 March 2024 in Sensors
Verified
Journal Article
Open access
PDF file
MFMichael Fletcher
Michael Fletcher
EPEric Paulz
Eric Paulz
DRDevin Ridge
Devin Ridge
Alan MichaelsAlan Michaels
Alan Michaels
The timely delivery of critical messages in real-time environments is an increasing requirement for industrial Internet of Things (IIoT) networks. Similar to wired time-sensitive networking (TSN) techniques, which bifurcate traffic flows based on priority, the proposed wireless method aims to ensure that critical traffic arrives rapidly across multiple hops to enable numerous IIoT use cases. IIoT architectures are migrating toward wirelessly connected edges, creating a desire to extend TSN-like functionality to a wireless format. Existing protocols possess inherent challenges to achieving this prioritized low-latency communication, ranging from rigidly scheduled time division transmissions, scalability/jitter of carrier-sense multiple access (CSMA) protocols, and encryption-induced latency. This paper presents a hardware-validated low-latency technique built upon receiver-assigned code division multiple access (RA-CDMA) techniques to implement a secure wireless TSN-like extension suitable for the IIoT. Results from our hardware prototype, constructed on the IntelFPGA Arria 10 platform, show that (sub-)millisecond single-hop latencies can be achieved for each of the available message types, ranging from 12 bits up to 224 bits of payload. By achieving one-way transmission of under 1 ms, a reliable wireless TSN extension with comparable timelines to 802.1Q and/or 5G is achievable and proven in concept through our hardware prototype.

27 August 2019 in IEEE Access
Verified
Journal Article
Open access
MFMichael Fletcher
Michael Fletcher
AMAlan Michaels
Alan Michaels
DRDevin Ridge
Devin Ridge

27 September 2026 in Electronics
Verified
Journal Article
Open access
PDF file
HPHogan Pope
Hogan Pope
MFMichael Fletcher
Michael Fletcher
Alan MichaelsAlan Michaels
Alan Michaels
Polar codes are a leading candidate for forward error correction (FEC) in short-block, burst-mode communication systems, yet few researchers have examined how they should be implemented in practice, including where the codec should sit on a mixed FPGA–processor platform. This paper evaluates that choice under direct-sequence spread spectrum (DSSS) ultra-reliable low-latency communication (URLLC) constraints on a system-on-chip with limited FPGA fabric area (Xilinx ZCU106), comparing six implementations across three locations: inline in the FPGA fabric, as a co-processor in the FPGA fabric but controlled by the ARM, and entirely in the Cortex-A53 software. The FPGA codec is area-bounded, which is reflective of the embedded space: a single datapath covering every code size in the waveform, which is selectable at runtime. The software is entirely off the shelf, including generated unrolled decoders. Each implementation is measured on end-to-end latency, throughput, energy per information bit, marginal hardware cost, and implementation flexibility. Software beats the co-processor, which was the only FPGA configuration built in hardware, on every metric, and the modeled inline placement only leads in latency for block lengths at or below N=64. The concluding design tradeoff is not a question of whether FPGA can decode faster than a processor, since with enough area it plainly can, but rather whether the area it can afford to spend is enough to justify placing the codec there.

1 November 2019
Verified
Conference Paper
Closed access
Alan MichaelsAlan Michaels
Alan Michaels
MFMichael Fletcher
Michael Fletcher
This paper presents a candidate arbitrary-phase spread spectrum modulation technique that offers similar performance to spread continuous phase modulation (CPM) waveforms, yet supports additional capabilities for programming a chosen frequency domain spectra into the resulting spread spectrum signal. The proposed frequency-selective high-order phase shift keying (PSK) signaling (FS-HOPS) waveform is derived from arbitrary-phase sequence-based spread spectrum signals, with multi-bit resolution chaos-based sequences defining incremental phase words, enabling real-time efficient generation of practically non-repeating waveforms. The result of the FS-HOPS formulation is a parameterized hybrid modulation capable of selectively mitigating narrowband interference. Adaptation in this modulation may be easily implemented as a time-varying evolution, increasing the security of the waveform against tone jammers, while retaining many efficiently implementable receiver design characteristics of standard PSK modulations.

5 September 2025 in Information
Verified
Journal Article
Open access
PDF file
MFMichael Fletcher
Michael Fletcher
JMJason McGinthy
Jason McGinthy
Alan MichaelsAlan Michaels
Alan Michaels
The rapid growth of Internet-connected devices integrating into our everyday lives has no end in sight. As more devices and sensor networks are manufactured, security tends to be a low priority. However, the security of these devices is critical, and many current research topics are looking at the composition of simpler techniques to increase overall security in these low-power commercial devices. Transmission security (TRANSEC) methods are one option for physical-layer security and are a critical area of research with the increasing reliance on the Internet of Things (IoT); most such devices use standard low-power Time-division multiple access (TDMA) or frequency-division multiple access (FDMA) protocols susceptible to reverse engineering. This paper provides a hardware validation of previously proposed techniques for the intentional injection of noise into the phase mapping process of a spread spectrum signal used within a receiver-assigned code division multiple access (RA-CDMA) framework, which decreases an eavesdropper’s ability to directly observe the true phase and reverse engineer the associated PRNG output or key and thus the spreading sequence, even at high SNRs. This technique trades a conscious reduction in signal correlation processing for enhanced obfuscation, with a slight hardware resource utilization increase of less than 2% of Adaptive Logic Modules (ALMs), solidifying this work as a low-power technique. This paper presents the candidate method, quantifies the expected performance impact, and incorporates a hardware-based validation on field-programmable gate array (FPGA) platforms using arbitrary-phase phase-shift keying (PSK)-based spread spectrum signals.