Stefan Hausberger

Prof. Dr. Stefan Hausberger


Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 July 2019 in Frontiers in Mechanical Engineering
Verified
Journal Article
Open access
KWKonstantin Weller
Konstantin Weller
SLSilke Lipp
Silke Lipp
MRMartin Röck
Martin Röck
CMClaus Matzer
Claus Matzer
ABAndreas Bittermann
Andreas Bittermann
SHStefan Hausberger
Stefan Hausberger
Real world emissions and energy consumption behavior from vehicles is a key element for meeting air iquality and greenhouse gas (GHG) targets for any country. While CO2 fleet targets for vehicles are defined on basis of standardized test procedures, real driving conditions manifold parameters show large variabilities. Main differences are The main differences are: driving cycle, vehicle loading and driving resistances, ambient temperature levels, start conditions and trip length, gear shift behavior of the drivers, power demand from auxiliaries, and fuel quality. For the upcoming update of the Handbook Emission Factors for Road Transport (HBEFA 4.1) we have performed analysis, measurements and simulations to simulate real world energy consumption values for 2-wheelers, passenger cars (PC), light commercial vehicles (LCVs), and heavy duty vehicles (HDVs), creating so called emission factors (EF). EFs show fuel consumption or emission level in [g/km] and [#/km] for fuel, gaseous exhaust gas components and also for the particle number (PN). EFs are provided for a lot of different traffic situations covering stop & go up to highway for different road gradient categories. EFs are different for each vehicle category and for each powertrain technology and emission standard (from EURO 0 gasoline PC to EURO VI HDV with CNG engine). To produce the EFs, vehicle tests from chassis dyno and from on-board measurements were collected in 18 independent European labs to set up models for all vehicle segments in the passenger cars and heavy duty emission model (PHEM). The models for PC and LCVs were based on weight and road load data available from the type approval test, the worldwide harmonized light vehicles test procedure (WLTP), and then calibrated in a stepwise approach to consider all influences in real world driving. Finally, the results for new vehicle fleet fuel consumption values were compared with data from the fuel consumption monitoring data base. For HDVs, the models are based on data from the development of the HDV CO2 determination method (Regulation (EU) 2017/2400, “VECTO”). The main findings of the updates for HBEFA 4.1 are: Exhaust pollutant emission levels from passenger cars with EURO 6d-temp type approval are below the limit values also in real driving conditions. HDVs new vehicles real world emissions are low already since introduction of EURO VI in 2013. Deterioration effects, ambient temperature effects on NOx from diesel cars and cold start emissions are relevant influences for the fleet average emissions. Real world CO2 emissions are clearly higher than type approval emissions for cars and LCVs. Higher average loading, shares of vehicle mileages with roof boxes or trailers, wet road, winter tires etc. as well as real world usage of auxiliaries, such as HVAC systems are main reasons for these differences.

26 April 2024 in Energies
Verified
Journal Article
Open access
PDF file
MOMartin Opetnik
Martin Opetnik
SHStefan Hausberger
Stefan Hausberger
CMClaus Uwe Matzer
Claus Uwe Matzer
SLSilke Lipp
Silke Lipp
LLLukas Landl
Lukas Landl
MEMiriam Elser
Miriam Elser
Although technical improvements to engines and aftertreatment systems have the greatest impact on pollutant emissions, there is also potential for reducing emissions through driver behavior. This potential can be realized in the very short term, while better emission-control technologies only take effect once they have penetrated the market. In addition to a change in driving style, the vehicle owner’s choice of vehicle technology and size class will also have an impact on the future emissions of the vehicle fleet. The effects of different driving styles, the tire choice, the vehicle size class, and propulsion technologies on energy consumption and tailpipe and non-exhaust emissions are analyzed in this paper for different traffic situations and start temperatures for cars with petrol and diesel combustion engines and for battery electric vehicles. The analysis is completed with the corresponding upstream emissions from fuel and electricity production. The analysis is based on a vehicle simulation using the Passenger car and Heavy-duty Emission Model (PHEM), which is based on a large database of vehicles created using measurements of real driving conditions. For the assessment of the driving style, a novel method was developed in an H2020 project, which reproduces a measured trip with a virtual eco-driver. Carbon dioxide equivalent emissions (CO2eq) increase with increasing vehicle size, but can be reduced by around 20% for conventional vehicles and 17% for battery electric vehicles (BEVs) through an environmentally conscious driving style. On average, BEVs have around 50% lower CO2eq emissions than conventional vehicles, if the emissions from vehicle production are also taken into account. On an average journey of 35 km, the cold start of modern diesel vehicles accounts for around half of the total NOx emissions, while the proportion of cold starts for petrol vehicles is around 25%. Tire and brake wear together generate a similar amount of PN23 emissions as the exhaust gases from new cars.

15 March 2024
Verified
Book Chapter
Closed access
PDF file
ZMZamir Mera
Zamir Mera
FRFredy Rosero
Fredy Rosero
Jairo Ortega OrtegaJairo Ortega Ortega
Jairo Ortega Ortega
RRRamiro Rosero
Ramiro Rosero
SHStefan Hausberger
Stefan Hausberger

5 December 2025 in Transportation Research Part D: Transport and Environment
Verified
Journal Article
Open access
ABAlvin Barbier
Alvin Barbier
JSJosé Miguel Salavert
José Miguel Salavert
SHStefan Hausberger
Stefan Hausberger
Carlos Enrique Palau SalvadorCarlos Enrique Palau Salvador
Carlos Enrique Palau Salvador
CGCarlos Guardiola
Carlos Guardiola

31 October 2026
Verified
Book Chapter
Open access
PDF file
AGAthina Grigoriadou
Athina Grigoriadou
GTGiorgos Triantafyllopoulos
Giorgos Triantafyllopoulos
DLDimitra Lekaki
Dimitra Lekaki
TKTraianos Karageorgiou
Traianos Karageorgiou
HSHeinz Steven
Heinz Steven
LNLeonidas Ntziachristos
Leonidas Ntziachristos
L-category vehicles, including mopeds, motorcycles, quadricycles, and all-terrain vehicles, represent a significant pollution source, particularly in urban areas. This study assesses the effectiveness of the following mitigation measures – introduction of Real Driving Emissions (RDE) testing, adoption of stricter World Motorcycle Test Cycle (WMTC) limits, enforcement of anti-tampering provisions, changes in the driving behavior, and acceleration of the fleet replacement. All of them are compared in parallel into two distinct baseline scenarios, a high and low electrification for the period 2025–2050, to quantify environmental benefits and support evidence-based policy decisions for L-category vehicles. The policies were simulated using fleet emission projection models and the assessment was based on existing and updated emission factors derived from emissions data collected through laboratory emission tests, on-road measurements and roadside tests. Results show that the introduction of RDE testing achieves the most substantial reductions in NOx and CO emissions, with declines exceeding 17% by 2050 compared to the baseline scenario, highlighting the significance of decreasing the gap between laboratory and real-world performance. The accelerated fleet replacement has its highest impact on HC emissions, whereas in other air pollutants, it shows significant impact as well. The remaining measures achieve consistent improvements across all pollutants.

3 January 2012 in ASEAN Engineering Journal
Verified
Journal Article
Open access
PDF file
THTuyen Pham Huu
Tuyen Pham Huu
SHStefan Hausberger
Stefan Hausberger
The substitution of conventional fuels (gasoline, diesel) by renewable biofuels including biodiesel and vegetable oil is considered as a potential solution not only for satisfying the fuel demand but also for reducing emissions. In this study, a Euro V truck fueled with a low sulphur diesel fuel, a neat biodiesel (B100), biodiesel blends (B7 and B10), a mixture of 7% biodiesel, 3% vegetable oil and 90% diesel (B7+3) and a straight vegetable oil was tested on chassis dynamometer under the European stationary cycle. During the test, emissions in the exhaust gas were collected and measured following the standard methods. Besides the regulated emissions, particle number and size distribution, which were sampled by volatile particle remover system compliant with the PMP requirement, as well as soot concentration, were also considered. Results show the effects of the tested fuels on the engine characteristics as well as the emissions.